2.1.3 Port-based VLAN - VOLKTEK Ethernet & fiber

More documents

Recommendations

Info

2.3.4 Config File Click “Backup” and select a device path to store configuration file. The default file name is “switch.cfg”. Click “Browse…” to select configuration file residing in your desktop or other network device, then press “Restore“ to overwrite system configuration. 28
3.0 Terminal Mode management Terminal mode is easy to operate; it is useful when in-band Ethernet communication was malfunction. No password is needed in terminal mode operation. Set up the terminal parameters, such as “Hyper Terminal” in Microsoft Windows System before you start the terminal mode connection. 1. Select COM #: COM 1, COM 2 … 2. Set “Baud rate” to 115,200 per second 3. Set “Attributes” to 8, None, 1, None (8 bit, No parity, 1 stop bit, No flow control). After you login into this system, the basic operation rules are shown below. Type ““ and press “Enter” to display usable commands, type “up“ or “ / “ to go back previous level of commands. > Commands at top level: System - System commands Console - Console commands Port - Port commands MAC - MAC commands VLAN - 802.1q (Tag-based) VLAN commands Aggr - Aggregation commands LACP - IEEE 802.3ad Link Aggregation commands RSTP - IEEE 802.1w Rapid Spanning Tree commands User Group - User Group (Port-based VLAN) commands QoS - QoS commands Mirror - Mirror commands IP - IP commands Dot1x - Dot1x commands IGMP - IGMP Snooping commands Debug - Debug commands > System commands: System> Commands at System level: 29
Page 1 and 2: 8-Port Gigabit Web Smart Switch NSH
Page 3 and 4: 1 Introduction The NSH-9308P Switch
Page 5 and 6: 1.2 Start to Manage This Switch Use
Page 7 and 8: 2.1 Configurations 2.1.1 System inf
Page 9 and 10: 2.1.2 Ports Port status page always
Page 11 and 12: 2.1.4 Tag-based VLAN Tag-based VLAN
Page 13 and 14: 2.1.5 Port Trunking Port Trunking d
Page 15: 2.1.7 Quality of Service QoS (Quali
Page 18 and 19: 2.1.9 LACP Different from the stati
Page 20 and 21: You can modify the following parame
Page 22 and 23: 2.1.12 802.1x Before you enable the
Page 24 and 25: 2.2 Monitoring 2.2.1. Port Statisti
Page 26 and 27: 2.2.5 IGMP Status Select “IGMP St
Page 30 and 31: System Configuration [all] System R

2.1.3 Port-based VLAN - VOLKTEK Ethernet & fiber

Create successful ePaper yourself

Delete template?

Save as template?