CA Dynam for VSE User Guide

System Adapter CANCEL-DELAY Support
System Adapter CANCEL-DELAY Support
This support is provided automatically without user intervention. When an
operator issues the CANCEL BG command, if CANCEL-DELAY is in effect, the
task is set to be canceled as usual; however, the cancellation does not occur
until the CA Dynam function in progress has completed. If the POWER/VS(E)
PFLUSH (F BG) command is issued while CANCEL-DELAY is in effect, message
CADS327E PFLUSH IGNORED is issued, and the command is ignored.
In either case, no further action should be taken until a reasonable time has
elapsed to permit the critical function to complete. If it is suspected that the
partition which has been canceled or flushed is in an unending loop or wait
condition, an override to the CANCEL-DELAY facility has been provided. The
operator can enter, to the attention routing (AR), any one of the following:
CA-CANCL nn or
CA-CAN nn or
CA-FLUSH nn where nn = partition ID of the partition to be canceled.
These commands disable the CANCEL-DELAY condition if it is in effect for the
partition specified and allow the previously entered CANCEL to take effect.
Note that these commands do not cause the job to be canceled, but merely
allow the cancellation to proceed.
TLBL/DLBL Extensions
CA Dynam products extend the TLBL and DLBL statements so that CA Dynam
processing options can be defined. The following charts summarize the
extensions.
TLBL Extensions
The TLBL Extensions include Standard TLBL and TLBL with CA Dynam
Extensions.
Standard TLBL
The Standard TLBL Extensions include the following:
// TLBL filename,'file-id', [ date ]
[ ,volser ]
[ ,volseq ]
[ ,fileseq ]
[ ,generation ]
[ ,version ]
1–6 User Guide