CA Dynam for VSE User Guide

Using CA Dynam/T
AR CASTART BG
BG CADT008D MOUNT SCRATCH TAPEOUT SYS011 DSN=AR TRANS MODE=1600
BG 299
BG CADT009D VERIFY VOLUME NO=100867
BG
BG CADT007I **** LABEL TAPEOUT SYS011=299 100867 1 *AR TRANS*
BG CADT031I *CLOSED* TAPEOUT SYS011=299 100867 AR TRANS BLK=12
BG EOJ ARUPD
DATE 01/21/09,CLOCK 20/05/53,DURATION 00/02/38
1. This creates file TAPEOUT, data set AR TRANS. Rewinds tape at close.
2. No SCRATCH tape is found during AVR, so the CADT008D message is
issued. A mode of 1600 BPI is required.
3. The operator responds STATUS to get a report of tape drives.
4. Drive 298 is DVCDN, 299 and 29A are available, ready at load point and
write enabled, with the indicated volumes mounted. Drive 29B is LOCKED
for use by another CPU.
5. The operator directs CA Dynam/T to 29A.
6. 29A contains an active data set volume; the MOUNT message is reissued.
7. The operator responds STOP to free the console while a SCRATCH tape is
mounted.
8. The operator reactivates the job with the CASTART command, and the
MOUNT message is reissued.
9. The operator directs CA Dynam/T to 299, which contains an uninitialized
labeled tape. The tape is initialized and processing continues.
Uncontrolled input, controlled output tape
BG // JOB COPY UNLABELED TAPE TO LABELED TAPE
DATE 01/23/09,CLOCK 20/30/33
BG // UPSI 001
TDYNCOPY CONTROL UPSI
BG // TLBL UOUT,'AR MASTER',,,,,,1
BG // EXEC TDYNCOPY
BG CADT001D UNASSIGNED INPUT TAPE UIN SYS004
BG 299
BG CADT008D MOUNT SCRATCH UOUT SYS005 DSN=AR MASTER MODE=1600
BG STATUS
BG CADT015I 298-UA-*DOWN*
BG CADT015I 299-BG-SYS004
BG CADT015I 29A-UA-RDY LP/W 999999 TEMP MASTER A
BG CADT015I 29B-UA-RDY LP/W 003912 PAY MASTER A
BG CADT008D MOUNT SCRATCH UOUT SYS005 DSN=AR MASTER MODE=1600
BG 29A
BG CADT009D VERIFY VOLUME NO=999999
BG 100456
BG CADT009D VERIFY VOLUME NO=100456
2–18 User Guide