ks0073 34com / 60seg driver & controller for dot matrix lcd

KS0073
34COM / 60SEG DRIVER & CONTROLLER FOR DOT MATRIX LCD
4) Display ON/OFF Control ( RE = 0 )
RS R/W DB7 DB6 DB5 DB4 DB3 DB2 DB1 DB0
0 0 0 0 0 0 1 D C B
Control display/cursor/blink ON/OFF 1 bit register.
D : Display ON/OFF control bit
When D = “High”, entire display is turned on.
When D = “Low”, display is turned off, but display data remains in DDRAM.
C : Cursor ON/OFF control bit
When C = “High”, cursor is turned on.
When C = “Low”, cursor is disappeared in current display, but I/D register preserves its data.
B : Cursor Blink ON/OFF control bit
When B = “High”, cursor blink is on, which performs alternately between all the high data and display
character at the cursor position. If fosc has 270 kHz frequency, blinking has 370 ms interval.
When B = “Low”, blink is off.
5) Extended Function Set ( RE = 1 )
RS R/W DB7 DB6 DB5 DB4 DB3 DB2 DB1 DB0
0 0 0 0 0 0 1 FW BW NW
FW : Font Width control
When FW = “High”, display character font width is assigned to 6-dot and execution time becomes
6/5 times than that of 5-dot font width.
The user font, specified in CGRAM, is displayed into 6-dot font width, bit-5 to bit-0,including the left
space bit of CGRAM.(Refer to Fig-16)
When FW = “Low”, 5-dot font width is set.
B/W : Black/White Inversion enable bit
When B/W = “High”, black/white inversion at the cursor position is set. In this case C/B bit of display
ON/OFF control instruction becomes a don’t car condition. If fosc has frequency of 270 kHz, inversion has
370 ms intervals.
NW : 4 Line mode enable bit
When NW = “High”, 4 line display mode is set. In this case N bit of function set instruction becomes
“don’t care” condition.