Helvar Lighting Controls 2013/14

More documents

Recommendations

Info

freedom in lighting DIGIDIM SYSTEM User Interfaces DIGIDIM stand-alone systems are typically small to mid-size applications that operate on a single DALI subnet, without the use of Helvar routers. User interfaces can be added to allow for manual scene setting, and multisensors can be used to increase energy efficiency in the application. Program and commission a DIGIDIM system using Toolbox Software. Modular Control Panels LCD Touchpanel STAND-ALONE SYSTEM BOUNDARIES • Up to 63 addresses per system • Up to 250 mA DALI supply per system • 10 mA per modular button panel • 10 - 40 mA per sensor • 2 mA per load interface • Each system may be configured with up to 16 groups • Each load may be programmed with up to 15 scenes See page 95 for additional information on system specification. Any latching or momentary switches via input units 444 440 3rd party AV-systems via RS232 interface 503AV Sensors 312 315 441 (3 rd party sensors) 6 Helvar | Data is subject to change without notice. More information at: www.helvar.com
Dimmers 455 452 416S / 425S 458/DIM8 + 458M1/8S10 Relay Units 490 494 498 458/SW8 + 458M1/8S10 Ballasts, drivers and controllers 458/CTR8 + 458M1/8S10 472 474 LED Accessories USB Interface System set-up and diagnosis with Toolbox-software (401) / (402) (510) Helvar | Data is subject to change without notice. More information at: www.helvar.com 7
Page 1 and 2: Lighting Controls 2013/14
Page 3 and 4: Helvar Lighting Systems Routers Int
Page 5: DIGIDIM for DALI Helvar’s DIGIDIM
Page 9 and 10: PanelPC with TouchStudio software B
Page 11 and 12: Ethernet esigner Software 920 Imagi
Page 13 and 14: DALI 1 Power/Status Dali 1 Dali 2 L
Page 15 and 16: 1000 W, Universal Dimmer (452) Sing
Page 17 and 18: 500 W, Thyristor Dimmer (455) Singl
Page 19 and 20: 4-Channel Ballast Controller (474)
Page 21 and 22: 2 Channel Blinds Controller (490) T
Page 23 and 24: 16 A 1-channel Relay Unit (492) Sin
Page 25 and 26: 4 Channel Relay Unit (494) Four cha
Page 27 and 28: 4-channel Thyristor dimmer module (
Page 29 and 30: 8-channel Universal dimmer module (
Page 31 and 32: 8-channel Switching module (458/SW8
Page 33 and 34: Single Mechanical Chassis (458M1/4S
Page 35 and 36: Double Mechanical Chassis (458M2/)
Page 37 and 38: 458-Series Installation Information
Page 39 and 40: Imagine 26 Channel Rack (HES26xxx)
Page 41 and 42: 2 Channel Transistor Dimmer (HES922
Page 43 and 44: 16 A Dimmer (416S) / 25 A Dimmer (4
Page 45 and 46: Control Modules (13xx) The 13xx pan
Page 47 and 48: EnOcean Switches (18xx) The 18xx wi
Page 49 and 50: 8 Scene & Modifier Panel (939) The
Page 51 and 52: Ceiling PIR Detector (311) The 311
Page 53 and 54: Low Profile Microwave Detector (313
Page 55 and 56: i Dim iDim System Sensor (315) The
Page 57 and 58:
Wall-Mounted PIR Presence / Absence
Page 59 and 60:
EnOcean Gateway (434) The 434 EnOce
Page 61 and 62:
Input Unit (440) The Input Unit is
Page 63 and 64:
Switch Interface Unit with LED Tell
Page 65 and 66:
LCD TouchPanel (924x) The TouchPane
Page 67 and 68:
Helvar IP Driver As one of the orig
Page 69 and 70:
uSee User Interface ENERGY MONITORI
Page 71 and 72:
USB-to-DALI Interface Unit (510) US
Page 73 and 74:
Power Supply (402) Fully DALI compa
Page 75 and 76:
PROGRAMMING During this stage the i
Page 77 and 78:
WORKFLOW The TouchStudio Editor pro
Page 79 and 80:
Helvar | Data is subject to change
Page 81 and 82:
Helvar’s LED drivers have been de
Page 83 and 84:
LC1x30-E-DA 1x30 W Dimmable DALI LE
Page 85 and 86:
LL1x70-E-DA 1x70 W Dimmable DALI LE
Page 87 and 88:
LC50-U-DX3 3 channel DMX LED driver
Page 89 and 90:
6 7 35 21 370 380 1 LL1x20-E-DA 2 L
Page 91 and 92:
DALI ELECTRONIC BALLASTS EL-iDim /
Page 93 and 94:
EL-iDim Digital DALI electronic bal
Page 95 and 96:
SPECIFYING INFORMATION System Compa
Page 97:
SPECIFYING INFORMATION Sensor selec
show all

Helvar Lighting Controls 2013/14

Create successful ePaper yourself

Delete template?

Save as template?