PSTC - Linear Actuator Drive - General Manual Rev 2.pdf

More documents

Recommendations

Info

PC Interface Software Section 1. Menu Structure PC Interface Switchboard Main Control Panel Idle Level – F1 – F10 Shift Level – F1 – F10 Ctrl Level – F1 – F10 Alt Level – F1 – F10 / CONFIGURE or /CFG Programmer’s Panel Idle Level – F1 – F10 Shift Level – F1 – F10 Ctrl Level – F1 – F10 Alt Level – F1 – F10 © 2003 Enhancement Electronics, Inc. 26
DOS Command Line Option Switches Standard Invocation: C:\SolarTrk\> STNG The following command line switches (preceded by a ‘/’, forward slash) allow special initialization options and the ability to work with stored data without being connected to a SolarTrak®. Template files and the Internal Template will be discussed in Section /Cn /Tfn /Ifn n = a COM port number, i.e. /c3 designates COM3 as the active port fn = filename of Template file ( .TPL), i.e. /tEAST01 will use EAST01.TPL This switch preloads EAST01.TPL but still contacts the SolarTrak® Same as /Tfn but goes directly to the internal template i.e. /iWEST01 loads and displays the data saved in WEST01.TPL without attempting contact with the SolarTrak® /M Monochrome screen operation (graphic plots will be hard to read) /Pn n = a PRINTER port number, i.e. /p2 designates LPT2 as the active printer. /Ffn fn = filename of PC Interface configuration file to use (default = ST_NET.CFG) Ex: /fNONET uses the file NONET.CFG /W Data from the on-board thermometer and the wind anemometer (if installed) will be collected and stored at 1-2 second intervals in daily files named WTyymmdd.DAT. Each file is approximately 2.5 Mb. File names change automatically at midnight. /Dn Position data (screw length, sun angle, etc.) from the on-board computations will be logged every ‘n’ minutes in a file named PDyymmdd.DAT. © 2003 Enhancement Electronics, Inc. 27
Page 1 and 2: Owner’s Manual For The SolarTrak
Page 3 and 4: The Powertracker Drive Unit Standar
Page 5 and 6: Determining the Current Operational
Page 7 and 8: Installation and Check-out Instruct
Page 9 and 10: 4. Dual 208 VAC Power Source w/Grou
Page 11 and 12: 4. 208 VAC Power Source w/Ground --
Page 13 and 14: Uncrating and Installation: Each sh
Page 15 and 16: Power Connection and Startup Sequen
Page 17 and 18: Display/Edit Parameters on SolarTra
Page 19 and 20: Section 5. Calibration to Onsite As
Page 21 and 22: 3. Press Enter/Select again. The di
Page 23 and 24: User Interface Module Section 1. Me
Page 25: pressing the A or B button moves th
Page 29 and 30: E: Setting up Batch File Execution
Page 31 and 32: INITIAL STARTUP: “Main Control Pa
Page 33 and 34: The Configure (CFG) Command: The CF
Page 35 and 36: Parameter Tables: Once in either th
Page 37 and 38: . Ax1 Gear Ratio : 3.7800 Timed Mot
Page 39 and 40: Moving Parameters between SolarTrak
Page 41: Array Angle S = -45° West L3 Linea

PSTC - Linear Actuator Drive - General Manual Rev 2.pdf

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?