You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
REPAIR<br />
BACKHOES<br />
pressure.<br />
4. Mark and remove hoses.<br />
5. Remove rod end (A) and then the base cylinder<br />
mounting pins (B) and remove cylinder.<br />
B<br />
Assemble<br />
Assemble in reverse order.<br />
A<br />
SWING CYLINDER(S)<br />
Removal:<br />
1. Position tractor with enough clearance to<br />
completely swing the boom extending the cylinder<br />
to be removed.<br />
2. Lower stabilizers with light pressure on the ground.<br />
M94997<br />
2. Swing bucket down to where it looks balanced<br />
below the dipperstick mast.<br />
3. Shut the engine off and activate the bucket control<br />
lever in both directions to relieve any pressure.<br />
4. Mark and remove hoses.<br />
5. Remove rod end (A) and then the base cylinder<br />
mounting pins (B) and remove cylinder.<br />
A<br />
B<br />
Install in reverse order.<br />
STABILIZER CYLINDER(S)<br />
Removal:<br />
1. Position tractor with enough clearance to<br />
completely extend the stabilizers.<br />
M94999<br />
3. Fully extend the swing cylinder to be removed.<br />
4. Shut the engine off and activate the swing control<br />
lever in both directions to relieve any pressure.<br />
5. Remove cylinder rod end (A) retaining pin.<br />
6. Mark and remove hoses.<br />
7. Remove base cylinder mounting pin (B) (Model 47)<br />
or retaining plate (Model 48) and remove swing<br />
cylinder.<br />
Install in reverse order.<br />
A<br />
B<br />
M94998<br />
2. Lower stabilizers with light pressure on the ground.<br />
3. Shut the engine off and activate the stabilizer<br />
control lever in both directions to relieve any<br />
3-24 6/22/99
Change language