TraumaCad Admin Guide - Voyant Health

16
Getting Started with the TraumaCad Server
TraumaCad Administrator’s Guide
Preparing for Installation
Before installing the TraumaCad server, perform the following:
• Verify that the system on which the TraumaCad server is to be
installed complies with all system requirements as specified in the
System Requirements section on page 13.
• If you want the TraumaCad server application to run using SSL, then
you must install an SSL certificate on the machine before installing the
TraumaCad server application.
If you decide that you want the TraumaCad server application to run
using SSL after the TraumaCad server application has already been
installed, the TraumaCad server must be uninstalled and then
reinstalled.
• Before installing TraumaCad server, define TraumaCad as a
DICOM node in your PACS server and supply the configuration details
to the TraumaCad support representative and/or the implementation
engineer as follows:
• IP address of TraumaCad server
• Application Entity (AE) Title of TraumaCad Server
• Port to be used for DICOM traffic (C-FIND, C-MOVE, C-STORE)
• Please visit the following URL in order to check the connectivity of the
TraumaCad server computer to our online licensing server:
http://ortho.securelm.net/LicenseIssueWs/IssueService.asmx
If a list of services is displayed, it means that the TraumaCad server
can connect to our server.
If this list is not displayed, it means that the TraumaCad server
computer is not connected to the Internet, or that the firewall/proxy in
your organization is blocking this connection. In this case, contact your
system administrator to enable this connection.
Also, please email the log file (typically under C:\Program\
Files\OrthoCad\TraumaCad\SecureLM.log) to
Support@TraumaCad.com.