PTI Bearing Catalog - Norfolkbearings.com

Bronze Journal Bearings
DIN 505 Series
DIN 505 Bronze bearings are designed for
applications in lumber, steel, chemical, waste
treatment and food industries. They will operate at
sliding speeds up to 1.5 m/sec (300 ft/min).
Housings are cast iron, journals are bronze.
These bearings are suitable for high temperature
applications: standard greases to approximately
110°C (230°F), synthetic or solid lubricants to
approximately 450°C (840°F). Lube is channeled
into the unloaded zone of the bearing cap through
a groove. Other journal types on request, see
other types below. Allowable loading: up to 450
N/cm 2 and sliding loads up to 250 (N·m)/(cm 2·s)
where:
N = bearing load (Newtons)
s = seconds
cm = surface area (centimeters)
m = meters
Part No.
Shaft
Wt.
a b
d 1 b 3 c d 6 d 7 d 8 h 1 h 2 m 1 m 2 1 kg
DIN505-25 25
DIN505-30 30
165 45 40 22 15 M12 M10 40 78 125 65 1.6
DIN505-35 35
DIN505-40 40
180 50 45 25 15 M12 M10 50 95 140 75 2.3
DIN505-45 45
DIN505-50 50
210 55 50 30 19 M16 M12 60 114 160 90 3.3
DIN505-55 55
DIN505-60 60
225 60 55 35 19 M16 M12 70 132 175 100 4.4
DIN505-70 70 270 65 60 40 24 M20 M16 80 154 210 120 7.1
DIN505-80 80 290 75 70 45 24 M20 M16 90 170 230 130 10.2
DIN505-90 90 330 85 80 50 28 M24 M20 100 188 265 150 13.4
DIN505-100 100
DIN505-110 110
355 95 90 55 28 M24 M20 110 210 290 170 19.0
DIN505-125 125 420 110 100 60 35 M30 M24 130 250 340 200 29.2
DIN505-140 140 440 125 120 65 35 M30 M24 150 280 360 220 39.0
Dimensions in mm.
Other DIN 500 Series Units
(Request Dimension Sheets)
DIN 502 DIN 503 DIN 504 DIN 506
P.T. International Corp.
212