Tailift Sales Manual - Worldwide Forklifts

Right angle stack calculations (wide load)
Aisle width; use narrowest aisle in which truck must right angle stack products. See illustration on facing
page 41 and formula below
Truck specs and load
solve for this number Clearance
from formula B below (see chart below)
Measured aisle
mm + mm = or less than
mm
in + in
Right angle stack formula B (wide load)
in
Determine if wide loads can be handled within available aisle clearance.
When D is greater than 2Z – C -2R, then the
aisle width =D + C +R + Y + required operator clearance
2 2
Note:
For three wheel trucks,
use formulas on page 38.
Y = D - C - R 2 + ( A + B) 2
2 2
Required aisle width for truck specs + load
=
D + C + R + Y
=
2
2
Insert above
Clearance Chart
Suggested minimum aisle /operator clearance chart
12192 mm / 40 ft long load - Add 1220 mm or 48 inches
9144 mm / 30 ft long load - Add 914 mm or 36 inches
6096 mm / 20 ft long load - Add 610 mm or 24 inches
3048 mm / 10 ft long load - Add 305 mm or 12 inches
1524 mm / 5 ft long load - Add 152 mm or 6 inches
1219 mm / 4 ft long load - Add 102 mm or 4 inches
53
Tailift Sales Manual 2005