Tailift Sales Manual - Worldwide Forklifts

More documents

Recommendations

Info

268 S.W. 32 nd Court Fort Lauderdale, FL 33315 Phone: (954) 768-9875 Fax: (954) 768-0077 MAINTENANCE AGREEMENT This agreement, made and entered into by and between, hereinafter called the “Customer”, and , hereinafter called the “Vendor”. WITNESSETH: That, in consideration of the premises, the Customer and the Vendor do hereby covenant and agree in these presents as follows: 1. EQUIPMENT: Vendor hereby agrees to maintain the Equipment described in the addendum on the terms and conditions set forth. 2. MAINTENANCE OF EQUIPMENT BY VENDOR: The Equipment will be serviced and maintained in proper working condition by Vendor, and Customer agrees to make the Equipment available for servicing by the representatives of Vendor, at reasonable times during Vendor’s business hours. Customer shall, upon request of Vendor, provide an adequate, separate area within Customer’s premises in which Vendor may service Equipment. In the event that any unit of Equipment shall be out of service for needed repairs, resulting from normal wear and tear, Vendor will arrange to repair such Equipment promptly after notice by Customer. Notwithstanding the foregoing, it is agreed that Vendor shall not be responsible for delays in servicing and maintaining equipment manufactured by others. Vendor shall use all reasonable means to accomplish needed repairs of such equipment promptly. Tire replacement will be limited to the number of sets shown on the addendum. Any tires in excess of the indicated sets are the responsibility of the Customer. All repairs will be made during Vendor’s normal working hours of _________ A.M. to ________P.M. _____________ thru __________________, which may be amended from time to time. Emergency repairs performed by Vendor before or after Vendor’s normal working hours, at the Customer’s request, shall be paid for by the Customer. Such payment shall be the difference between the prevailing straight and overtime rates of the Vendor. 3. SURVEY REPORT: The maintenance rates specified herein only cover predictable normal wear and tear and are based on the operating conditions described in the survey report dated__________, which report is hereby made part of this Agreement. The rates do not cover accidental damage, misuse, overloading or repairs due to poor housekeeping. Changes in the Customer’s operation of the Equipment from that as shown in the Survey Report may require a maintenance rate renegotiation, at Vendor’s option. Vendor reserves the right to cancel the maintenance portion of this Agreement if Customer and Vendor cannot agree on adjusted rates within a thirty (30) day period, commencing with the date of the Vendor’s request for renegotiation. 4. CARE OF EQUIPMENT BY CUSTOMER: Customer agrees to take good care of the Equipment and, without limiting the foregoing, to use and operate the same within its rated capacity, to restrict the use and operation thereof to careful and competent personnel selected, employed, and controlled by Customer, to prohibit anyone other than duly authorized personnel of Vendor to make any repairs or adjustments to the Equipment (unless otherwise previously authorized in writing by Vendor). The Customer will notify Vendor immediately of any accident, disability, or failure of Equipment, and furnish vendor in writing with all pertinent facts, in connection with any accident. Customer will reimburse Vendor for any loss due to damage to or destruction of Equipment, excepting normal wear and tear. Vendor will be sole judge of normal wear and tear. Customer shall supply all necessary fuel, oils, water, anti-freeze, and other normal needs of Equipment in its daily operation. Customer shall perform the daily operator’s checks at the beginning of each shift, in accordance with the manufacturer’s recommendations. Customer shall also maintain proper level of water in batteries, recharge the batteries and change the LP gas cylinders, as required. Customer, at its own expense and risk, shall be responsible for the foregoing and for the installation cost of charging equipment and the storage of LP gas fuel and cylinders. 5. EXCESS HOURS: The estimated operating hours are shown in the addendum. If the actual operating hours determined from meter readings exceed such estimated operating hours, the excess hours shall be billed at the excess hour rates shown in the addendum. In the event that any hour meter fails to function, the operating hours shall be ascertained by using the average from the previous two (2) months of recorded usage. 59 Tailift Sales Manual 2005
6. PAYMENTS: Customer agrees to pay monthly maintenance charges specified in the addendum, in advance, for the full term shown, commencing on the first day of the month immediately following the signing of this Agreement. Customer agrees to pay all other proper charges under this Agreement when due. Delinquent payments shall bear interest at legal rate until paid, at the option of the Vendor. 7. TAXES: All sales, use, and other taxes and assessments levied upon or against service maintenance hereunder shall be paid by the Customer. 8. TERMS: The terms on each unit of Equipment shall be as specified in the addendum. 9. LOCATION OF THE EQUIPMENT: Equipment shall be located as specified in the addendum. Equipment shall not be removed from this address without prior written consent of Vendor and shall be used solely in the conduct of Customer’s business. 10. FORCE MAJEURE: Vendor assumes no liability to Customer for failure to perform, if prevented by wars, riots, labor disputes, laws or regulations, labor or material shortages, fuel allocation programs, or other causes beyond Vendor’s control. Notwithstanding Vendor’s inability to perform under such conditions, the Customer’s obligations as described in paragraph four (4), shall continue. 11. ENTIRE AGREEMENT: Vendor has not made any representations of any kind, nature or description except as are in the Agreement specifically set forth, and this Agreement contains all the terms and agreements entered into between the parties. Vendor is irrevocably authorized to insert herein serial numbers and any further description of Equipment and the date of the Agreement. IN WITNESS WHEREOF, Customer and Vendor have executed this Agreement this day ________of ____________, 20____. Customer Vendor By (if a corporation, show title of officer) By (if a corporation show title of officer) Address Address City, State, Zip City, State, Zip 60 Tailift Sales Manual 2005
Page 1 and 2:
INDEX Glossary 1-3 Explanation of f
Page 3 and 4:
Indicated horsepower: The horse pow
Page 5 and 6:
Explanation of forklift terms Load
Page 7 and 8:
Turning radius The radius of the lo
Page 9 and 10: These angles are essential for asse
Page 11 and 12: Weight Truck weight: Total weight o
Page 13 and 14: 12 Tailift Sales Manual 2005
Page 15 and 16: Lift Truck Class I-VII Class I - El
Page 17 and 18: TAILIFT IC CUSHION MAST SPECIFICATI
Page 19 and 20: TAILIFT IC CUSHION MAST SPECIFICATI
Page 21 and 22: TAILIFT IC PNEUMATIC MAST SPECIFICA
Page 23 and 24: TAILIFT IC PNEUMATIC MAST SPECIFICA
Page 25 and 26: TAILIFT LPG AND DIESEL TRUCK WEIGHT
Page 27 and 28: TAILIFT LPG AND DIESEL TRUCK WEIGHT
Page 29 and 30: DUAL PNEUMATIC TIRES MODEL SIZE P.R
Page 31 and 32: English to Metric Conversion Factor
Page 33 and 34: DECIMAL EQUIVALENTS OF FRACTIONS 1/
Page 35 and 36: Grade in degrees and percent Degree
Page 37 and 38: Part 1 1. Maximum weight lifted kg
Page 39 and 40: 4. Product Data 4a. Type of Product
Page 41 and 42: 5. Towing consideration (if applica
Page 43 and 44: 8. Ventilation conditions Consider
Page 45 and 46: 11. Boxcar loading or unloading (if
Page 47 and 48: 13. Overhead Obstructions Maximum o
Page 49 and 50: 16. Ramp data (if not applicable, g
Page 51 and 52: Part 2 Bulk Storage Calculations Ai
Page 53 and 54: Right angle stack illustration (nor
Page 55 and 56: Right angle stack illustration (wid
Page 57 and 58: Intersecting aisle illustration A =
Page 59: Summary Sheet 1.- Maximum weight li
Page 63 and 64: Circle one answer from each questio
Page 65 and 66: A. Visibility is improved. B. The t
Page 67 and 68: Check at the beginning of each 8 ho
Page 69: Engineering and Standards Informati
show all

Tailift Sales Manual - Worldwide Forklifts

Create successful ePaper yourself

Delete template?

Save as template?