Low Temperature Mechanical Properties Of Copper and Selected ...

List of References
1. NBS Institute for Materials Research, Cryogenics Division, Boulder, 28. Bengough, G. D., A study of properties of alloys at high temperatures,
Colo., Experimental data obtained on contract for International J. Inst. Metals 7, 123(1912).
Copper Research Association and Copper Development Associa- 29. Benham, P. P., Axial-load and strain cycling fatigue of copper at low
tion (1965).
endurance, J. Inst. Metals 89, 328 (1961).
2. Achter, M. R., Mechanical behavior of metals in vacuum (Inst. En- 30. Benham, P. P., Torsional-strain-cycling fatigue of copper at low en
vironmental Sci. Proc., 1963), p. 385.
durance,.!. Inst. Metals 91,404(1963).
3. Achter, M. R., Danek, Jr., G. J., Smith, H. H., Effect on fatigue of Benson, N. D., McKeown, J., Mends, D. N., The creep and softening
gaseous environments under varying temperature and pressure, properties of copper for alternator rotor windings, J. Inst. Metals
Trans. AIME 227, 1296 (1963).
80,131 (1951 )-[Ref. 376|.
4. Adams, M. A., The plastic behavior of copper crystals containing Beresnev, B. /., Balychev, D. A., Mechanical properties of Al and Cu
zinc in the surface layer, Acta Met. 6, 327 (1958).
after high-pressure extruding, Fiz. Metal Metallov. (USSR) 16, 117
Adams, M, A., Higgins, P. R. B., The hardening of copper by neutron (1963)-[Ref. 380].
irradiation, Phil. Mag. 4, 777 (1959)-[Ref. 433]. 31. Bhattacharya, S., Congreve, W. K. A., Thompson, F. C., The creep-
5. Alder, J. F., Phillips, V. A., The effect of strain rate and temperature time relationship under constant tensile stress, J. Inst. Metals 81,
on the resistance of aluminum, copper, and steel to compression,
83 (1952).
J. Inst. Metals 83,80 (1955).
Blank, A. /.. Burghoff, H. L., Creep characteristics of phosphorized
6. Alers, G. A., Thompson, D. 0., Dislocation contributions to the modulus copper (0.019 percent /') at 300, 400, and 500F. Proc. ASTM 51,
and damping in copper at megacycle frequencies, J. Appl. Phys.
981 (1951)-[Ref. 362].
32,283(1961).
Blatherwick, A. A., Mowbray, D. F., Stress-strain relationships in
Alers, G. A., Zimmerman, J. E., Dislocation mobility in fee metals below low-and-intermediate-cycle fatigue, Proc. ASTM 64, 561 (1964) —
1 °K, Phys. Rev. 139, A414 (1965)-[Ref. 364].
[Ref. 428].
7. Alien, N. P., Recent European work on the mechanical properties 32. Bleakney, H. H., The ductility of metals in creep-rupture tests, Ca
of metals at low temperatures, NBS Circ. 520 (1952), p. 1.
nadian J. Technology 30, 340 (1952).
8. American Metal Co., Ltd., OFHC Brand Copper (American Metal Blewitt, T. //., Low temperature irradiation studies, Proc. Intn.
Co., Ltd., New York, 1957).
School Physics, E. Fermi Course XVIII (Radiation Damage in
9. Am. Soc. Mech. Engr., Am. Soc. Testing Mat., Compilation of Avail Solids, Academic Press, New York, 1962), p. 630-[Ref. 395J.
able High Temperature Creep Characteristics of Metals and 33 Blewitt, T. H. Coltman, R. R., Redman, J. K., Low temperature defor
Alloys (1938).
mation of Cu single crystals, J. Appl. Phys. 28, 651 (1957).
Amfiteatrova, T, A., YampdoVsky, B. Ya., Deformation of metals at 34. Blewitt, T. H., Coltman, R. R., Jamison, R. E., Redman, J. K., Radia
low stresses. II —Influence of adsorption-active media on creep tion hardening of copper single crystals, J. Nuclear Materials 2,
of copper and aluminum, Phys. Metals Metallog. 7, #5, 130(1959) — 277(1960).
[Ref.413]. 35. Blewitt, T. //., Deformation of copper single crystals at 300 degrees
10. Anderson, A. R., Swan, E. F., Palmer, E. W., Fatigue tests on some
K and 78 degrees K, Phys. Rev. 91,1115 (1953).
copper alloys, Proc. ASTM 46,678 (1946). 36. Blewitt, T. H., Coltman, R. R., Redman, J. K., Work hardening in
11. Anderson, A. R., Smith, C. S., Fatigue tests on some copper alloys, copper crystals, Proc. Phys. Soc. (London) B67, 369 (1954).
Proc. ASTM 41,849 (1941). 37. Bokshtein, S. Z., Kishkin, S. T., Svetlov, I. L., Tensile testing of fila
12. Argent, B. B., The tensile properties of the alpha brasses, J. Inst. ment crystals of copper, nickel and cobalt to failure. Soviet Phys.
Met. 93,460(1965).
Solid State 4, No. 7, 1272 (1963).
13. Awada, M. Iwano, A'., Tanisawa, H., Yosida, S., Yamagata, K., Me- 33. Bolton, J. W., Hehemann, F. H., Discussion on properties of copper
chanical properties of castings of aluminum bronzes, S. Japan and its alloys. Symposium on Effect of Temperature on the Prop
Foundrymen's Soc., Imono, 32,948(1960).
erties of Metals (ASTM and ASME. Philadelphia, Pa., 1931), p. 361.
14. Azhazha, V. M., Gindin, I. A. Starodubov, Ya. D., Shapoval, B. I., 39. Boone, W. D., Wishart, H. B., High-speed fatigue tests of several
Influence of deformation at low temperatures on creep and internal ferrous and nonferrous metals at low temperatures, Proc. ASTM
friction of copper, Fiz. Metal. Metallov. 15,729(1963).
35, 147 (1935).
15. Backofen, W. A., Shaler, A. J., Handy, B. B., Mechanical anisotropy 40. Bordoni, P. G., Elastic and anelastic behavior of some metals at very
in copper, Trans, ASM 46, 655 (1954).
low temperatures, J. Acoust. Soc. Am. 26, 495 (1954).
16. Bailey, A. R., The fracture characteristics of brass in impact at at Bovet, H., Zirconium alloyed copper, Pro-Metal 13, 375 (I960)-[Ref.
mospheric and elevated temperatures, J. Inst. Metals 89, 339
399J. •
(1961).
Bregowsky, I. M., Spring, L. W.. The effect of high temperatures on
17. Baird, C., Jennings, P. //., The effect of low-temperature annealing the physical properties of some alloys (Proc. (Pt. II) Intn. Assoc.
on the indentation hardness of cold-worked alpha-brass, J. Inst. Testing Mat., 6th Congr., New York, 1912). Section VII-[Ref.
Metals 89, 191 (1960-61).
449].
18. Baker, W. A., Creep of non-ferrous metals and alloys, A review of 41 Breen, J. E., Lane, J. R., Effect of dispersion of alpha brass on the high
published information, Brit. Non-Ferrous Met. Res. Assoc. Rept. temperature fatigue properties of alpha-beta brass, Trans. ASM
#449, (1937).
49, 959 (1957).
19. Balasse, G., Gaspard, R., Tensile-test curves for copper (wire) under 42. Breen, J. E., Lane, J. R., Effect of grain size on high temperature
constantly increasing load, Compt. Rend. 245, 497 (1957).
fatigue properties, Trans. ASM 46, 1021 (1954).
20. BarnbyJ. T., The spacing of slip lines in metals. AST1A (Nov. 1961). 43 Brombacher, W. 6., Temperature coefficient of the elastic moduli
21. Baron, H. G., Effect of strain rate on the tensile stress-strain char
of spring materials used in instrument design. Rev. Sci. Inst. 4,
acteristics of metals, Metal Treat. 29, 25 (1962).
688(1933).
22. Baron, H. G., Stress-strain curves of some metals and alloys, J. Iron 44 Bronieivski, W'., Szreniawski, J., L influence de la temperature et de
Steel Inst. 182,354(1956).
Tecrouissage sur les proprietes mecaniques d'um bronze pous
Baron, I . V., Savitskii, E. M., The effect of temperature on the medailles. Rev. Met all. 33, 442 (1936).
strength of brittle metallic substances, Dokl. Acad. Nauk. (SSSR) 45 Broniewski, W., Wesolowski, K., L'influence de la temperature sur
94, 269(1954)-[Ref. 403].
les properties meehaniques de laitons. Rev. Metall. 30, 396. 453
23. Barren, C. R., Sherby, O. D., Influence of stacking-fault energy on
(1933).
high-temperature creep of pure metals, Trans. AIME 233, 1116 45 Brooks, H. E., Johnston, H. L., Hardness of various metal? at low tem
(1965).
peratures down to 20° absolute, ASTIA Rept. 161564 (1952).
Barren, C. R., Sherby, O. D., Steady-state creep characteristics of 47. Bruner, L. J., Mecs, B. M., Modulus and damping of copper after plas
polycrystalline copper in the temperature range 400° to 950 °C,
tic deformation at 4.2 degrees K, Phys. Rev. 129, 1525 (1963).
Trans. AIME 230, 1322 (1964)-[Ref. 443]. 48. Buck, O., Deformation and electrical resistance of copper single
24. Bassett, W. H., Discussion on properties of copper and its alloys. crystals at very low temperatures. Phys. Stat. Solidi 2, 535 (1962).
Symposium on Effect of Temperature on the Properties of Metals 49 Buell, M. A., Grain size is important, Prod. Engr. 33, 46 (1962).
(ASTM and ASME, Philadelphia, Pa. 1931), p. 351. 50! Bullen, F. P., Hutchison, M. M., The temperature-dependence of
25. Beevers, C. J., Barnes, R. S., The microhardness of copper bombarded strain-hardening in polycrystalline copper. Phil. Mag. 8,461 (1963).
with alpha particles, J. Inst. Metals 89, 125 (1960). 51 Buloic, C. L., Copper and its alloys for low temperature versatility,
26. Belton, J. H., Godby, L. L., Taft, B. L., Materials for use at liquid Chem. Eng. 67, 187(1960).
hydrogen temperatures, ASTM Spec. Tech. Publ. 287, 108 (1961). 52. Bulou', C. L., Properties of copper alloys at cryogenic 1 temperatures.
Bendler, H. M., Nine, H. D., Fatigue failure in copper single crystals Engr. Design News 9, 70 (1964).
at low and high amplitudes of torsion. Nature 194, 1069 (1962)- 53. Bulychev., D. K., Beresnev, B. /., Gaydukor, M. G., Martynoi, E. D.,
[Ref. 434].
Radionov, E. D., Ryabinin, Yu. \., Structural defects and plastic-
27. Bengough, G. D., Hanson, D., The tensile properties of copper at high deformation of copper at high pressures. Dokl. Acad. Nauk. (SSSR)
temperatures, J. Inst. Metals 12, 56 (1914).
156,67(1964).
153