Low Temperature Mechanical Properties Of Copper and Selected ...

More documents

Recommendations

Info

$Standard X-ray Diffraction Powder Patterns$

$Standard X-ray Diffraction Powder Patterns$

$Standard X-ray Diffraction$

have undoubtedly missed some pertinent references, ft however it is hoped that these omissions are minimal. ft-lb Finally, for a publication of this magnitude, many others G.L. have taken part. The authors wish to thank L. Berenbaum gm and W. Hawkesworth who have helped in the preparation G.S. of the tables and graphs. Mrs. L. Cottony provided valuable hr assistance in the procurement of over 700 papers which K were examined in this Monograph. The authors wish to Kc.p.s. express their gratitude to L. Ericks, who was responsible kgm for the majority of the figure drafting, and to Mrs. C. Dall- KT man, who performed most of the typing. Also, as previously stated, the authors are indebted to the International Copper Research Association, who have provided the necessary funds for the performance of this program. List of Abbreviations ASTM American Society for Testing Materials approx. approximately atmos. atmosphere Bal. balance C degrees Celsius (centigrade) c.p.m. cycles per minute c.p.s. cycles per second diam. diameter F degrees Fahrenheit Mc.p.s. mm nvt psi R r.p.m. R(J-) sec. temp. U.T.S. Y.S. foot, feet foot-pound gage length gram grain size hour degrees Kelvin kilocycles per second kilogram stress concentration factor L/2 distance between notches notch radius megacycle per second millimeters integrated flux pounds per square inch ratio of applied minimum to maximum stress in fatigue tests revolutions per minute Rockwell hardness number, scale (x) second temperature ultimate tensile strength yield strength
Section I In this section average values, taken from all investiga tions used in Sections II and III, are plotted. This is intended for quick reference. Contents Page Mechanical properties of copper........................................................... 2 Mechanical properties of Cu-Zn (brass).................................................. © 4 Mechanical properties of Cu-Sn (phosphor bronze)................................... 6 Mechanical properties of Cu-Si (silicon bronze) and Cu-Ni-Si.................... 8 Mechanical properties of Cu-Ni............................................................ 10 Mechanical properties of Cu-Al-Fe (aluminum bronze) and Cu-Al-Fe-Ni......... 12
Page 1 and 2: CI3.44:Jdl Low Temperature Mechanic
Page 3: UNITED STATES DEPARTMENT OF COMMERC
Page 7: Low-Temperature Mechanical Properti
Page 11 and 12: Mechanical Properties of Copper TEM
Page 13 and 14: Mechanical Properties of Cu-Zn (Bra
Page 15 and 16: Mechanical Properties of Cu-Sn (Pho
Page 17 and 18: Mechanical Properties of Cu-Si (Sil
Page 19 and 20: Mechanical Properties of Cu-Ni rlli
Page 21: j Mechanical Properties of Cu-Al-Fe
Page 24 and 25: Contents Copper Tensile and yield s
Page 26 and 27: Tensile and Yield Strength of Coppe
Page 34 and 35: Tensile Elongation of Copper TEMPER
Page 36 and 37: Tensile Elongation of Copper TEMPER
Page 38 and 39: Tensile Elongation of Copper (Oxyge
Page 40 and 41: ! i ! s?l • ,j o. I 3 p - 0 5' o
Page 42 and 43: Tensile Reduction of Area of Copper
Page 44 and 45: Tensile Stress-Strain Curves of Cop
Page 46 and 47: Hardness of Copper TEMPERATURE, *F
Page 48 and 49: Fatigue Behavior of Copper CURVE NO
Page 50 and 51: Fatigue Behavior of Copper (Electro
Page 52 and 53: Creep Behavior of Copper Cf KV*. CO
Page 54 and 55: \ Creep Behavior of Copper COMPOSIT
Page 56 and 57: Creep Behavior of Copper (Oxygen-Fr
Page 58 and 59:
Stress-Rupture Behavior of Copper C
Page 60 and 61:
Modulus of Elasticity of Copper TEM
Page 62 and 63:
Tensile and Yield Strength of 95Cu-
Page 64 and 65:
Fatigue Behavior of 95Cu-5Zn (Glidi
Page 66 and 67:
Page 68 and 69:
Impact Energy of 90Cu-10Zn (Commerc
Page 70 and 71:
. Modulus of Rigidity of 90Cu-10Zn
Page 72 and 73:
Tensile Stress-Strain Curves of 85C
Page 74 and 75:
! 1 Creep Behavior of 85Cu-15Zn (Re
Page 76 and 77:
1 Tensile and Yield Strength of 80C
Page 78 and 79:
Fatigue Behavior of 80Cu-20Zn (Low
Page 80 and 81:
Tensile Reduction of Area of 71Cu-2
Page 82 and 83:
Modulus of Elasticity of 71Cu-28Zn-
Page 84 and 85:
j j j Tensile Elongation of 70Cu-30
Page 86 and 87:
Fatigue Behavior of 70Cu-30Zn (Cart
Page 88 and 89:
\ 1 Fatigue Behavior of 70Cu-30Zn (
Page 90 and 91:
Tensile Elongation of 65Cu-35Zn (Ye
Page 92 and 93:
Modulus of Elasticity of 65Cu-35Zn
Page 94 and 95:
Tensile Elongation of 60Cu-39Zn-lSn
Page 96 and 97:
| i Impact Energy of 60Cu-39Zn-lSn
Page 98 and 99:
Modulus of Elasticity of 60Cu-39Zn-
Page 100 and 101:
Tensile Reduction of Area of 60Cu-4
Page 102 and 103:
Fatigue Behavior of 60Cu-40Zn (Munt
Page 104 and 105:
Page 106 and 107:
Impact Energy of 90Cu-10Ni TEMPERAT
Page 108 and 109:
Page 110 and 111:
t il u 0 1 2 N. O ISf 5-2E "is !" n
Page 112 and 113:
Page 114 and 115:
| Impact Energy of 70Cu-30Ni CURVE
Page 116 and 117:
Modulus of Elasticity of 70Cu-30Ni
Page 118 and 119:
Impact Energy of 55Cu-45Ni TEMPERAT
Page 120 and 121:
Tensile Reduction of Area of Cu-Ni-
Page 122 and 123:
Tensile and Yield Strength of Cu-Si
Page 124 and 125:
Impact Energy of Cu-Si (Silicon Bro
Page 126 and 127:
Fatigue Behavior of Cu-Si (Silicon
Page 128 and 129:
Tensile and Yield Strength of Cu-Sn
Page 130 and 131:
Tensile Reduction of Area of Cu-Sn
Page 132 and 133:
Fatigue Behavior of Cu-Sn (Phosphor
Page 134 and 135:
Creep Behavior of Cu-Sn (Phosphor B
Page 136 and 137:
Tensile and Yield Strength of Cu-Al
Page 138 and 139:
Tensile Elongation of Cu-Al (Alumin
Page 140 and 141:
Tensile Stress-Strain Curves of Cu-
Page 142 and 143:
\ i Fatigue Behavior of Cu-Al (Alum
Page 144 and 145:
Tensile and Yield Strength of Cu-Al
Page 146 and 147:
Tensile Stress-Strain Curves of Cu-
Page 148 and 149:
Creep Behavior of Cu-Al-Ni (Nickel
Page 151 and 152:
1. Reference Guide for Review Paper
Page 153 and 154:
i 3. Reference Guide for Experiment
Page 155 and 156:
5. Reference Guide for Experimental
Page 157:
7. Reference Guide for Experimental
Page 161 and 162:
List of References 1. NBS Institute
Page 163 and 164:
120. Gillett, H. W., Impact resista
Page 165 and 166:
219. McEvily, A. J., Boettner, R. C
Page 167 and 168:
333. Wellinger, K., Seufert W., Unt
Page 169:
NBS TECHNICAL PUBLICATIONS PERIODIC
show all

Low Temperature Mechanical Properties Of Copper and Selected ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?