Advantage GPX 33 - Paint Sprayers, HVLP Sprayers, Powered Rollers

More documents

Recommendations

Info

Cleanup -Oil-BasedMaterials1 2 3SPRAYPRIMEStartYou will need:• Mineral spirits if using oil-based material• Warm, soapy water if using latex material• Waste containerFollow these steps if you sprayed oil-basedmaterials, or if you sprayed latex materialsand do not have a garden hose available.Be sure to use the appropriate cleaningsolution for the type of material sprayed.1. Perform Pressure ReliefProcedure (page 7).2. Remove the spray tipand place into an emptywaste container.3. Attach the supplied grounding wireto a grounded object.Submerge suction set into abucket with the appropriatecleaning solution.4 567SPRAYSPRAYPRIMEPRIME4. Start the engine (see instructionson page 4).Point the spray gun at the side ofa waste container.Ground the gun against theside of a metal waste containerif flushing with mineral spirits.5. While squeezing thetrigger, turn the powerON, and turn the PRIME/SPRAY knob to SPRAY.6. Continue squeezing the triggeruntil fluid is coming out clear.You may need to get newcleaning solution.7. Perform Pressure ReliefProcedure, page 7.If you flushed the sprayer with mineralspirits repeat the steps on this pageusing warm, soapy water.English18
Cleaning theSpray GunComponents1SPRAYPRIME23StartYou will need:• Soft bristled brush• Light household oil• Warm, soapy water if using latex material• Mineral spirits for oil based material• Wrenchimportant: DO NOT use any siliconebasedlubricants to clean or lubricate thespray gun.1. Peform the PressureRelief Procedure, page 7.(a)2. Pull trigger guard to separatefrom filter housing and unscrewhousing using a wrench.Note: Tighten the wrench over thewrench flats (a).3. Remove filter from spray gun.Clean spray tip and filter with softbristled brush and appropriatecleaning solution.4567(b)HOUSEHOLDOIL(c)4. Pour a few drops of lighthousehold oil inside gunhousing.5. Install gun filter taperedendfirst. Reassemblespray gun.6. Line up the tabs (b) on thespray tip with the slots in theguard assembly.Slide the tip into the guard.7. Install spray tip and guardassembly.Move on to Long TermStorage, page 20.19English
Page 5 and 6: Proper useand functionsSPRAYPRIMEPR
Page 7 and 8: Pressure Safety ReliefProcedure**Pe
Page 10 and 11: Start4. PracticeSprayingYou will ne
Page 12 and 13: SprayingTroubleshooting -Clear theS
Page 14 and 15: SprayingTroubleshooting -Clean theI
Page 16 and 17: StartCleanupMINERALSPIRITSorYou wil
Page 20 and 21: Long TermStorage1 2OILHOUSEHOLDStar
Page 22 and 23: TroubleshootingBefore servicing, al
Page 25 and 26: Parts List • Liste de Pièces •
Page 27 and 28: Parts List • Liste de Pièces •
Page 29: Limited WarrantyAIRLESS PAINT SPRAY

Advantage GPX 33 - Paint Sprayers, HVLP Sprayers, Powered Rollers

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?