Bel PRO 200 - Best Radar Detector

TroubleshootingProblemSolutionProblemSolutionThe Pro200 beeps briefly at thesame location every day, but noradar source is in sight.• An X or K-band motion sensor or intrusion alarm islocated within range of your route. With time, you will learnpredictable patterns of these signals.Your 14-year old son has changedall 6 of the Programming options.• You can return all of the programming options to thefactory defaults by holding down the CITY and BRT buttonswhile you turn the Pro200 on.The Pro200 does not seem sensitiveto radar or laser.• Make sure that windshield wipers do not block yourPro200’s radar antenna and that the laser lens is not behindtinted areas.• Determine if your vehicle has an Instaclear ® , ElectriClear ®or solar reflective windshield which may deflect radar or lasersignals.• Your Pro200 may be in City Mode.The Pro200 will not turn on.The Pro200 feels very warm.• Check that the power is ON.• Check that vehicle ignition is ON.• Check that vehicle lighter socket is functional.• Try the Pro200 in another vehicle.• It is normal for the Pro200 to feel warm.The Pro200 did not alert when apolice car was in view.The Pro200 did not provide a Safetysignal while within range of anemergency vehicle.The Pro200’s display is not working.The Pro200’s audible alerts are lessloud after the first few alerts.• VASCAR (Visual Average Speed Computer and Recorder) astopwatch method of speed detection, may be in use.• Officer may not have radar or laser unit turned on.• Safety transmitters may not be commonly used in your area.• Press the BRT button to deactivate Dark Mode.• The Pro200 is in AutoMute Mode. See page 8 for details.Explanation of DisplaysAD Sensitivity control is in AutoScan mode, display is in Dark mode (page 9)HD Sensitivity control is in Highway mode, display is in Dark mode (page 9)CD Sensitivity control is in City mode, display is in Dark mode (page 9)No display The Pro200 is in the Dark mode (page 9)PilotHWY One of the many programming messages (pages 11-14)The Pro200 bounces or sags onwindshield.The Pro200’s power-on sequencereoccurs while you are driving.• The Pro200 is not making contact with the windshieldto provide stability. While holding down the Pro200’sQuickMount button, slide the Pro200 toward the windshieldso that the back top edge makes firm contact.• A loose power connection or dirty lighter socket can causethe Pro200 to be briefly disconnected.WorkZone One of the many Safety Radar messages (pages 20-21)CautionSelf CalServiceRequired22 23The Pro200 has detected a Safety Radar Signal, but the signal isn’t yet strongenough to decode the specific safety message (page 20-21)The Pro200 is running a self-calibration testThe Pro200 has failed the calibration test. Contact Beltronics for repair