2254/R User Manual - AMS Neve

More documents

Recommendations

Info

<strong>2254</strong>/R Limiter Compressor Issue 2.4MeterThe programme meter is operated by a simple drive circuit with rapidattack and slow decay times, that correspond to the typical PPMcharacteristic.The green led to the right side of the meter will light at a threshold ofabout -10dBu.The led turns red when the program reaches a level of +25dBu, indicatingimminent clipping.The meter can be set to display either the Input signal level (In), Outputsignal level (Out) or the amount of gain reduction applied to the signal bythe compressor and limiter in total (Control).This selection is set with the adjacent Meter knob.- 8 -
<strong>2254</strong>/R Limiter Compressor Issue 2.4Rear PanelLine InputInput XLR.Pin 1Pin 2Pin 3ScreenHiLowOutputOutput XLR.Pin 1Pin 2Pin 3ScreenHiLowSet GainThis trim pot (situated next to the Output XLR) allows you to set theoverall gain of the unit to be 0dB in and 0dB out.This is useful, if for example, the load of the unit connected to the Outputis 600Ω.This would mean the level of the unit would drop by about 1dB, so theGain Trim allows you to compensate for this.The default factory setting is 0dB in, 0dB out, with a load of 100kΩ.- 9 -
Page 1 and 2: 2254/RLimiter CompressorUser Manual
Page 3 and 4: 2254/R Limiter Compressor Issue 2.4
Page 6: 2254/R Limiter Compressor Issue 2.4

2254/R User Manual - AMS Neve

Create successful ePaper yourself

Delete template?

Save as template?