Manual - FuturePlus Systems

More documents

Recommendations

Info

Configuration ModeFigure 10: Result of Filter combined with Summary DisplayModeIn this mode of operation, the inverse assembler displaysinformation about how the FS4300 Analysis Probe is configured.Figure 11 shows an example of a Configuration mode display.The configuration data is only available on states representingFibre Channel primitive words (e.g. IDLE). If there are none ofthese states in the analyzer’s memory, no configurationinformation will be displayed.32
Figure 11: Configuration Display ModeUsing Symbols toTrigger in StateMode.The labels and symbols provided may be used to trigger on thevarious fields of a frame. There are two types of labels. One typeof label is used to define values for fields within the frame (e.g.source and destination Ids). The other type is used to qualifythose fields within the data passed to the analyzer.The following sections give some examples of how to use theselabels.Triggering on a FrameType & fields within aframe.The FrmTyp label may be used to define a trigger termspecifying the required type of Frame. Symbols are defined for anumber of different frame types. The FrmTyp label is validthroughout a frame so may be used to qualify triggering on otherfields within a particular frame type. For example setting up atrigger term that defines the conditions FrmTyp = FCP_CMD,WrdTyp = Payload, Count = 003 and Data = 12xxxxxx (hex) willcreate a trigger for a SCSI Inquiry command. In this example thevalue of FrmTyp specifies a FCP command, the WrdTypspecifies a state representing payload and the combination ofCount and DATA specify that the 3 rd payload word must be12xxxxxx (hex). The most significant byte of the 3 rd word of anFCP command frame payload holds the CDB opcode (in thiscase Inquiry) so the combination of labels specifies the SCSIInquiry command33
Page 1 and 2: FuturePlus Systems CorporationFibre
Page 3 and 4: One Channel Only 14Two Channels usi
Page 5 and 6: How to reach usFor Technical Suppor
Page 7 and 8: IntroductionThe FS4300 Fibre Channe
Page 9 and 10: Figure 1: The FS4300 Fibre Channel
Page 11 and 12: TX OK LEDComma Detect LEDSIG OK LED
Page 13 and 14: LogicAnalyzerNumber of PODSrequired
Page 15 and 16: Installing theAnalysis ProbeThe Fib
Page 17 and 18: Fibre Channel NodeFibre Channel Nod
Page 19 and 20: The Inverse AssemblerThe Fibre Chan
Page 21 and 22: Word TypeNode_IDs(SOF)SyncingLinkOp
Page 23 and 24: selection switches both set to the
Page 25 and 26: header is preceded by a ‘|’, th
Page 27 and 28: Frame ControlFieldUse Values Displa
Page 29 and 30: Figure 6: Full Display ModeSummary
Page 31: Figure 8: Setting up a data filter
Page 35 and 36: Duplicate primitiveand data filteri
Page 37 and 38: The FS4300 also provides a mechanis
Page 39 and 40: Priority Error Description1 Link Er
Page 41 and 42: General InformationCharacteristicsA
Page 43 and 44: Primtv SymbolLIP failLIPLPELPE allL
Page 45 and 46: FrmTyp SymbolDefinitionF_RJT 111100

Manual - FuturePlus Systems

Create successful ePaper yourself

Delete template?

Save as template?