VITOTRONIC 100, HC1 VITOCONTROL-S, WB2B Installation and ...

Initial start-upFurther step-by-step instructions (continued)Update the LON particiapant list on Vitocontrol-S, WB2BOnly possible if all users are connected and the control unit is encoded as fault manager (coding 79 : 1 factory defaultsetting)Note:In each heating system, only one Vitotronic may be encoded as fault manager.1. Press w and simultaneouslyfor approx. 2 s.The participant check is initiated.2. Press D.The participant list is updatedafter approx. 2 min.Participant check completed.Example of a LON systemVitocontrol-S Vitotronic 200-H Vitotronic 200-HVitocomLONLONLONParticipant no. 5Code ”77:5”Participant no. 10Set code ”77:10”Participant no. 11Set code ”77:11”Participant no. 99Send time via LONCode ”7b:1”Accept time via LONSet code ”81:3”Accept time via LONSet code ”81:3”Time received via LONTransmit outdoor temperaturevia LONSet code ”97:2”Receive outdoor temperaturevia LONSet code ”97:1”Device receives the timeCarrying out a participant checkThe communication with the system devices connected to the fault manager is tested by means of a participant check.Preconditions: The control unit must be programmed as fault manager (code 79:1). The LON participant number must be programmed in all control units(see page 31). The fault manager participant list must be up to date.Participant checkF01 : 011Consecutivenumber in theparticipant listParticipantnumber1. Press w and simultaneously forapprox. 2 seconds.2. Select the required participant withand .3. Activate check with .”Check” flashes until its completion.The display and all key illuminationsof the selected participant flash forapprox. 60 seconds. During communication betweenboth devices ”Check OK” isdisplayed. ”Check not OK” is displayed, if nocommunication is established.Check the LON connection andcoding.4. To check further participantsproceed as described under points 2and 3.5. Press w and simultaneously forapprox. 1 second.5414 553 v1.432