Pumps - PT Hydraulics

®CE General Guidelines• All operating instructions must be provided in the original languageand the language that the end user(s) understand completely. Weprovide these with our Declarations of Incorporation upon requesteven though it is not required until the final level machine is completelyassembled.• All Safety Warning Decals must be provided in the language thatthe end user(s) understand completely. We also provide theseupon request for our units having a Declaration of Incorporation.• Electrical machines must comply with the Machinery SafetyDirective 89/392/EEC, the Low Voltage Directive 73/23/EEC andthe EMC Directive 89/336/EEC.• Safety of Machinery-General EN60204-1 compliance is also•required.Emissions Immunity and Low Voltage tests must be conducted bya qualified lab on a representative sample machine which will be•produced with electrical controls and circuits.In production, each individual machine must undergo specific circuittests, like a hipot test for insulation breakdown, as required bythe applicable standards.•All electrical components are to be IEC approved.All hoses are to be ISO approved with a 4 to 1 safety factor, burstto working pressure. These hoses are 1/4" ID and can be providedby us upon request.•Schematics must be drawn to European standards.ALL wires must be marked and must correspond to the schematic•wire numbers.Compliance with the EMC and LVD Directives requires aDeclaration of Conformance and CE mark.•The manufacturer must establish a Technical Construction File.Declarations of Conformance must accompany the OperatingInstructions for the machine and be translated into the same languageas the Operating Instructions.• Safety of Machinery standard EN292-1 asks that ALL FORESEE-ABLE hazards be removed, safeguarded or warned against in the•Operating Instructions.Pictograms and other graphics should follow standards such as•ISO7000 for consistency and conformity.Annex 1 of the MSD specifically requires that Principles of SafetyIntegration 1.1.2, Marking 1.7.3. and Instructions 1.7.4 apply to all•machinery covered by the directive.Noise emissions must be included in the Operating Instructions for•operator areas.Components such as fittings, gauges, fasteners, non-electricalmechanical devices, valves, etc., are NOT REQUIRED to be individuallycertified. CE conformance is assured by the final level assemblydocumentation and testing required by the MSD.• Individually marketed Safety Components must have a Declarationof Conformity, but CANNOT have a CE mark applied.•Lifting machines have stricter requirements.There are 24 other directives being considered for CE approval at•this time.The existing directives are being amended and modified and it isthe responsibility of the manufacturer to remain current with thesechanges. For example, the MSD has 3 amendments: 91/368/EED,93/44/EEC and 93/68/EEC.3E3ERev. 3-3-97