Model 610AR Installation and Maintence Instructions Drive Axle Air ...
Model 610AR Installation and Maintence Instructions Drive Axle Air ...
Model 610AR Installation and Maintence Instructions Drive Axle Air ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Installation</strong> <strong>Instructions</strong> <strong>Model</strong> <strong>610AR</strong>Gap is clearof interferrence21200011819Weld LocationWITH THE AXLE BLOCKED UPROUGHLY AT RIDE HEIGHT,PERFORM:TRACK ROD BRACKET, AXLEMOUNTING:1. Obtain Track Rod Bracket (18), that mounts toaxle. Note: location varies with frame width, seatangles, etc.2. Depending upon application, locate on axle perprint.NOTE: This location must be done at properride height. Track Rod should be as level aspossible at ride height.3. When all is properly located, weld to axle perprint on page m.6.Track Rod AssemblyAssemble Bolt Side Up19202623TRACK ROD INSTALLATION:1. Obtain the applicable track rod (19), <strong>and</strong> installthe 7/8 bolts (15), 7/8 locknuts (16), <strong>and</strong>flatwashers (17), at each end. Snug the 7/8locknuts, but do not tighten.2. With the suspension at proper ride height,tighten the 7/8 track rod end nuts to 400-425 Ftlbs.1516173. With the track rod adjusted to optimum length(spring beams parallel <strong>and</strong> centered), tighten thetrack rod clamp nuts to 125-150 Ft-lbs.<strong>Drive</strong> <strong>Axle</strong> <strong>Air</strong>-Ride Suspension Systemi.8
Change language