Gigaset N720 DECT IP Multicell System

More documents

Recommendations

Info

IntroductionHow to proceedUse the following guide to quickly locate the most important topics.Information on ...... is located here.Determining the requirements for the telephone networkDetermine the requirements for the telephone network and collectinformation about the environmental conditions for the plannedDECT wireless network.gpage 9Creating an installation planCreate a building plan and enter the planned DECT base stations inthis plan. You should take account of the general conditions determinedand the technical requirements of DECT telephony in theprocess.gpage 18Taking measurementsUse the installation plan to take measurements and adapt the installationplan to your measurement results.gpage 20Working with the Gigaset measuring equipmentHave you purchased the Gigaset N720 SPK PRO (Site Planning Kit)?Here you can read about how to set up the measuring equipmentand how to use it to take measurements.gpage 29Special environmentsDo you want to set up your DECT network in a difficult environment?Helpful information and tips are available here.gpage 41If you have any questions about using your measuring devices, please contactour Customer care team (£ page 43).8VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Projecting the DECT networkProjecting the DECT networkThere are a number of conditions to be considered when setting up a DECT network. Theyaffect the subscribers' requirements for the telephone system as well as the technicalrequirements for the DECT wireless network. These conditions must therefore berecorded and evaluated in a projection phase.To project your DECT network, proceed as follows:u First determine the requirements for the telephone network and establish the environmentalconditions for the DECT wireless network.u Define how many base stations are required and their probable optimum positioning.Create an installation plan for the base stations.u Take measurements to check whether the positioning of the base stations at theassumed positions meets the requirements and whether the reception and soundquality is sufficient everywhere. If necessary, change the installation plan to optimisethe DECT wireless network.Determining the requirements for the telephone networkClarify the following questions to determine the requirements for the telephone network:Subscribers and subscriber behaviouru How many employees should be able to make calls and how many subscribers shouldbe able to make calls simultaneously?– How many handsets are required?– How many base stations are required?u Where should telephone calls be possible?– In which buildings (floors, stairwell, basement, underground garage)?– Outdoors (on footpaths, on the car park)?For more information about this, please refer to the information in the section Outsidearea, £ page 42.– How are the handsets distributed from a location perspective?u How many calls will be made?– What is the telephony behaviour of the subscribers? How long is the average call?– Where are the hotspots, i.e., where do a lot of subscribers gather simultaneously(open-plan office, canteen, cafeteria, etc.)?– Where are telephone conferences held? How many telephone conferences are heldand how long are these?Environmental conditionsu Where is the site that is to be covered by the DECT wireless network?– Total area of the required wireless coverage– Position and dimensions of the rooms, building plan– Number of floors, basements¤ Request a building plan that shows positions and dimensions and that can be usedto document the subsequent installation planning.9VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Page 1 and 2: N720 DECT IPMulticell SystemSite Pl
Page 3 and 4: Table of ContentsTable of ContentsS
Page 5 and 6: IntroductionIntroductionThis docume
Page 7 and 8: Criteria for an optimum DECT wirele
Page 9: IntroductionOverlapping and synchro
Page 13: Projecting the DECT networku Mainta
Page 17 and 18: Alternative calculation for small s
Page 19 and 20: Interference from other cells and n
Page 21 and 22: Projecting the DECT networkPosition
Page 23 and 24: Taking measurementsu Document the p
Page 25 and 26: Connection qualityTaking measuremen
Page 27 and 28: Taking measurementsMeasuring the ce
Page 29 and 30: Taking measurements¤ Install the m
Page 31 and 32: Working with the Gigaset N720 SPK P
Page 33 and 34: Before you beginWorking with the Gi
Page 35 and 36: Please noteu The measuring station
Page 43 and 44: DECT installations in special envir
Page 45 and 46: EnvironmentCustomer care and helpQu
Page 47 and 48: AppendixSpecificationsHandset batte
Page 49 and 50: GlossaryGlossaryBandwidthThe bandwi
Page 51 and 52: ErlangFrameGlossaryUnit which measu
Page 53 and 54: IndexAAuthorisation . . . . . . . .
Page 55: A31008-M2316-L101-2-7619VoIPon www.

Gigaset N720 DECT IP Multicell System

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?