Operator Manual - Barrett BORS - NIOA LEM

CHANGE SETTINGSCalibrating BORS to the rifle telescopeThere are three times when calibrating BORS to the scope will be required:1. After initial mounting of BORS to the scope.2. If the elevation dial is adjusted while BORS is powered off and settings arelost.3. Loss of power to BORS when in use. This does not include automatic BORSPower Off for a low battery.CautionDo not attempt to turn the rifle scope’s elevation knob past its designedmechanical limit during calibration.Calibration procedure:1. Rotate the BORS elevation knob clockwise until it reaches its lowest point.2. Press the button to enter the menu screen.3. Press the button until the screen displays “CHANGE SETTINGS”.4. Press the button. The screen will display “ADJUST BACKLIGHT”.5. Press the button once. The screen will display “DEVICE SETUP”.6. Press the button to select this screen.7. Press the button to display “ZERO ELEVATION”.8. Press the button to select thisscreen. BORS will prompt to“CONFIRM” or “CANCEL” thecalibration as shown in Figure 4-4.9. Press the button to “CONFIRM”,or the button to “CANCEL” thecalibration. “DEVICE SETUP” willbe displayed.Figure 4-4NoteThe calibration will not be properly completed if “CANCEL” is selected.10. Press the button until the “OPERATOR”S SCREEN” is displayed.Calibration is completed.17