DocuPrint P205 b User Guide - Fuji Xerox Printers

Printing ProblemsProblemPrinter stops during print job.Job did not print or incorrectcharacters printed.Print media misfeeds or multiplefeeds occur.ActionCheck if the message appears on the Printer Setting Utility. If the"Cooling Down Wait a few minutes" message appears, the printer iscooling down because the printer temperature is too high. Please waita few minutes.After the printer cools down, the printing will restart.Ensure that the (Ready) LED is lit.Ensure that print media is loaded in the printer.Verify that you are using the correct print driver.Ensure that you are using the correct USB cable and that it issecurely connected to the printer.Verify that the correct print media size is selected.If you are using a print spooler, verify that the spooler has not stalled.Ensure that the print media you are using meets the specifications foryour printer.See also:• "Usable Print Media" on page 61Fan the print media before loading it.Ensure that the print media is loaded correctly.Ensure that the paper width guides and length guide are adjustedcorrectly.Do not overfill the print media sources.Do not force print media into the multipurpose feeder (MPF) whenyou load it. Otherwise, it may skew or buckle.Ensure that the print media is not curled.Load the recommended print side correctly for the type of print mediayou are using.The envelope is creased afterprinting.Page breaks in unexpectedplaces.Print media does not stack neatlyin the center output tray.See also:• "Loading Print Media" on page 63Turn the print media over or around and try printing again to see iffeeding improves.Do not mix print media types.Do not mix reams of print media.Remove the top and bottom curled sheets of a ream before loadingthe print media.Load a print media source only when it is empty.Ensure that the envelope is loaded as instructed in "LoadingEnvelope in the Multipurpose Feeder (MPF)" on page 69.Increase the value for Fault Time-Out in the System Settings menuthat is on the Printer Maintenance tab in the Printer Setting Utility.Turn the print media stack over in the multipurpose feeder (MPF).109 Troubleshooting