Front-mounted external venetian blind type R 6/10

More documents

Recommendations

Info

Spare parts/removal7 Spare parts/repairsCAUTIONPersonal injury or property damage resultingfrom inappropriate repairs.• The product should only be repaired by aspecialist.To ensure that your product operates properly on acontinuous basis and to avoid changing its approvedstatus, use WAREMA spare parts only. Please contact aqualified specialist for further information.8 Removal/disposalCAUTIONPersonal injury or property damage resultingfrom improper removal.• The product should only be removed by aspecialist.Removal and re-installation of the product must beundertaken by a qualified specialist in accordance withcurrent guidelines and standards. Be sure to ask themanufacturer for any missing documents beforecommencing removal or re-installation.Should the product no longer be required, ensure that itis disposed of correctly in accordance with the relevantregulations.[B866866_0] - EN / 01.04.08 Page <strong>10</strong> of 12 Subject to change without notice.
Troubleshooting9 TroubleshootingCAUTIONPersonal injury or property damage resultingfrom troubleshooting.• Problems with no reference to a qualifiedspecialist may be rectified independently.• Other problems are only to be dealt with bya qualified specialist.Problem Possible causes RemedyMotor is not operating. Motor is malfunctioning.Motor change (specialist only) On-site motor connection is incorrect. Motor thermal protection switch hastriggered There is no current In the upward direction, the motorswitches off when the allowable torquelimit is exceeded (only with comfortswitch-off for icing)Reconnect as per wiring diagram(electricians only)Wait <strong>10</strong> to 15 minutes, then try againCheck the power fuse (electriciansonly)Issue a short downward command;When the unit moves down: stop theunit and check whether its path isblocked.If so: clear the blockage and issue adownward commandIf the motor stops again: teach-in themotor again for this product(specialists only)Bottom rail does not move to limitpositions A higher-level control command ispresent Motor switch-off positions are incorrect Guide rails are soiledAwait switch on/off delayReadjust the motor (specialists only)Remove soiling[B866866_0] - EN / 01.04.08 Page 11 of 12 Subject to change without notice.
Page 1 and 2: WAREMA front-mounted external venet
Page 3 and 4: Product information2 Product inform
Page 5 and 6: Operation3 Operation NOTEIf using a
Page 7 and 8: General safety information4 General
Page 9: Maintenance/warranty5.3 Maintenance

Front-mounted external venetian blind type R 6/10

Create successful ePaper yourself

Delete template?

Save as template?