Front-mounted external venetian blind type R 6/10

Operation3.2 Front-mounted external venetian blind with an electric motorExtending/retracting or tilting with a rotary or pushbutton switch• Press and hold the (UP)button or (DOWN) button.Or• Turn the toggle to the left orright and hold.The slat position changes orthe external venetian blindmoves in the selected direction.The external venetian blindstops when the button or toggleis released.The blinds can be stopped atany position. The limit stop ofthe external venetian blind islimited in both directions ofmovement, i.e. the externalvenetian blind automaticallystops at this point.Extending/retracting or tilting with a snap-in switch• Press the (UP) button or(DOWN) button.Or• Turn the toggle to the left orright.The slat position changes orthe external venetian blindmoves in the selected direction.The external venetian blind isstopped by pressing the stopbutton, pressing the button forthe opposite direction or turningback the toggle.The blinds can be stopped atany position. The limit stop ofthe external venetian blind islimited in both directions ofmovement, i.e. the externalvenetian blind automaticallystops at this point.Extending/retracting with an external control unitA wide range of control devices is available for our sunprotection systems to give you optimum control of theexternal venetian blind. Please contact your qualifiedspecialist for further information.Instructions on how to operate this feature are contained ina separate manual.Information for motor runtimeThe motors used in these products are not intended forcontinuous operation. The integrated thermal protection willswitch the motor off after approx. 4 minutes. The productwill be ready for use again after approx. 10-15 minutes.CAUTIONProduct damage!The external control unit may fail underextreme conditions (e.g. power failure ordefects).• Set the external control unit to manual if youare going to be away.[B866866_0] - EN / 01.04.08 Page 6 of 12 Subject to change without notice.