Front-mounted external venetian blind type R 6/10
Front-mounted external venetian blind type R 6/10
Front-mounted external venetian blind type R 6/10
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
TroubleshootingProblem Possible causes RemedyCrank rod is difficult or impossibleto turn Mechanism is blocked or defectiveReplace the gear drive (specialistsonly)Slats cannot be adjusted, <strong>external</strong><strong>venetian</strong> <strong>blind</strong> does not move upExternal <strong>venetian</strong> <strong>blind</strong> extendsand retracts erraticallyCoupled <strong>blind</strong> reacts with a delayor not at allBottom rail is resting on thetension bracket (only if additionalwind protection is in use) Crank or pivot bearing is defective Hexagonal input shaft is not aligned Hexagonal input shaft is too short forthe drive Lifting tape is torn Lifting tape is torn Blockage in the vicinity of the guide Blockage in the vicinity of the tiltingtape Coupling of turning stem is missing Fixing screw of the coupling tube isloose Tension bracket is installed too highReplace the pivot bearing (specialistsonly)Rework the drilled hole (specialistsonly)Replace the pivot bearing (specialistsonly)Replace the lifting tape (specialistsonly)Replace the lifting tape (specialistsonly)Retract (extend) the <strong>blind</strong> a shortdistance and then extend (retract) itagain.If the fault occurs again: Fully retractthe <strong>external</strong> <strong>venetian</strong> <strong>blind</strong> and informthe specialist.Slide coupling tube onto turning bar ofdrive <strong>blind</strong> and tighten fixing screw(specialists only)Tighten the fixing screw (specialistsonly)Correct the tension bracket position(specialists only)Tab. 3:Overview of possible problemsThis technical documentation contains copyrighted Company stampcompany information. All rights reserved.The information in this documentation and the productitself are subject to change without notice. All brands andproduct names mentioned in this documentation aretrademarks or registered trademarks of the respectiveholder.Considerable care was taken in producing the text andgraphics in this documentation. No liability is accepted forany errors which may nevertheless exist in thisdocumentation nor for the consequences of any sucherrors.© 2009, WAREMA Renkhoff SE, Hans-Wilhelm-Renkhoff-Straße 2, 97828 Marktheidenfeldhttp://www.warema.de • E-mail: info@warema.de
Change language