FLENDER gear units - DS TECH

© Siemens AG 2011Options for installation and attachment partsHousing torque arm (single arm)■ Dimensioned drawingscG 10G 2Ø 60aaD1G_MD30_XX_00099bGear unitsizesNominal outputtorqueT 2NNmDimensions in mmD 1 G 2 G 10 a b c Weight,approx.30 10000 375 132 25 55 225 435 12.535 15000 425 115 25 60 240 480 1537 20000 450 122 25 70 260 555 18.540 25000 480 125 35 80 310 690 2945 35000 540 135 35 90 330 725 3250 45000 585 135 35 110 430 905 4955 65000 670 185 35 130 410 1065 7260 80000 695 206 35 130 500 1065 72kg(450) 655-7447info@pt-dstech.comwww.dstech.ca8In the case of shaft-mounted gear units with a torque arm, the connection between the torque arm and foundation must always permitthe gear unit to move in accordance with the bearings of the machine shaft, without constraining forces acting on the gear unit.Ordering informationWhen ordering the housing torque arm, -Z should be added to the order number.Data position of the Order No. 1 to 6 7 8 9 10 11 12 13 14 15 16 Order codeOrder No. 2LP069 . - 0 . . . . - . . . . -ZHousing torque arm (single arm)Prepared for mounting a housing torque arm (single arm)M10M11Mounting of a twin housing torque arm is supported as standard.If a single housing torque arm is used, special bearings are required.This is also necessary if the housing torque arm is not included in the order, but the customer plans to use it.If a single housing torque arm is used, compliance with the minimum dimension c for the length of the lever arm is essential.1275 Newton, local 15Boucherville, Qc,Canada, J4B 5H28/2 Siemens MD 31.1 · 2011