POD HD500 Advanced Guide (Rev G) - English.pdf - Musifex

Features & FunctionalityMoving FX BlocksAny of the 8 FX Blocks can be moved throughout your tone’s signal flow, providingtremendous routing flexibility. To move any FX Block, start within the Signal Flow Viewand select the FX Block to be moved. Press the MOVE button and you’ll see the selectedFX Block appear “raised” to indicate it is now moveable.ENTERAMP & FX ON / OFF3•5DBL PRESS TO ASSIGN CTLMOVEPressing the Move button to reposition an FX BlockThe FX Block can now be moved as follows:• Use theNav. Disc buttons to move the FX Block to the desired position.• Move the FX Block into either Path A or B, and place it before or after an AmpModel within the path. Use the Nav. Disc buttons to move the FX Block tothe opposite path. This allows you to run your effect in “parallel” and blend theindividual Path A & B outputs using the Mixer’s Level & Pan options!• Once the FX Block is in the desired position, press the MOVE button again to dropit into place.• Amp Blocks can be moved into fixed positions within the Pre or Post signal pathareas, or within the Paths A & B - see “Amp Model Positioning” on page 6•1.• The Looper can also be selected and moved either to the start (“Pre”) or end (“Post”)of the signal flow - see “Looper Mode” on page 8•1.