DT-CONFIG SOFTWARE USER'S MANUAL - Schick Handel

More documents

Recommendations

Info

5.3. NameList SetupDT-CONFIG (DMR11) SOFTWARE USER’S MANUALPanel ConfigurationTo select the Door Station and Expanded Panel combination in a specific entrance. Please notethe total Call Buttons are limited to 32. If Cancel Button and Manage Button (Call Guard Unit)are needed, click [Control Button] check option, and then specify the Call Buttons to be used.If User Code of this entrance isn’t regularly arranged, set [Start User Code] if necessary.After above operations, press Auto Set button to create a User Code mapping.You can modify the User Code mapping if necessary. Also, you can click Clear Button Positionbutton to clear the mapping, and assign the Call Button by manual.User Code, Name List and DIP Programming informationEdit the grids to fill Room No and Name Label, please note limitation less than 20 chars.You can sort the table by Room No, or by Name Label. Use Download Button Position button todownload Call Buttons mapping to connected Door Station.After editing, you can export the Name Label and User Code information to TXT file, so as tocreate a printable name label file, which can be used to replace the Door Station name labels.Download NameList informationIn 2-wire DT system, Monitors will display a intercom NameList menu for intercom calling. Thisname dictionary is transmitted from Door Station, and should be previously downloaded fromDT-CONFIG software. After editing NameList information in software, press DownloadNameList to save into Door Station. In field installation, when Monitors are installed, use DoorStation PA button to transmit name dictionary to Monitors, see technical manual for reference.16
DT-CONFIG (DMR11) SOFTWARE USER’S MANUALPrint User Code programming tableUse Print Button to print a field programming reference document, it is much useful ininstallation and after-installation service.Part of printing job as below, including configuration and reference table:… …17
Page 1 and 2: DT-CONFIG SOFTWAREUSER’S MANUALVi
Page 3 and 4: 1. IntroductionsDT-CONFIG (DMR11) S
Page 5 and 6: DT-CONFIG (DMR11) SOFTWARE USER’S
Page 11 and 12: 3.3. Get Te COM Port NumberDT-CONFI
Page 18 and 19: 6. Assess Control settingsDT-CONFIG
Page 20: DT-CONFIG (DMR11) SOFTWARE USER’S

DT-CONFIG SOFTWARE USER'S MANUAL - Schick Handel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?