SMP Calibration Kits - Spectrum Elektrotechnik GmbH

Suggested for Hewlett Packard ANAOpen-Short-Load-Throughline Calibration KitsProfessional Calibration Kit11 11 1213 1313 13 1312310disk1414 14 14 144 5 67 8 915 15 151617 18 19The actual layout of the Calibration Kit may differ from the schematic above, it also depends on the connectorseries and its size (this applies also for the No. of Gauges). The Instrument Cases for Standard, Expanded andthe Professional Kit are same per Connector series. You may start with a Standard Calibration Kit and fill theempty spots at a later stage to end up with an Expanded or even the Professional Calibration Kit.Description of Equipment Provided1: Short female2: Short male3: Open Circuit female4: Open Circuit male5: Fixed Termination female6: Fixed Termination male7: Throughline female-female8: Throughline female-male9: Throughline male-male10: Software configurationmedium11. Torque wrenchSuggested forHewlett Packard ANAProfessional Calibration Kit12: Set of Double ended wrenches13: Set of full Interface Gauges for centerconnector location/outer conductordimensions*14: Set of Gauge Calibration Blocks15: Set of Thread Limit GaugesInstrument caseOperating instructions16, 17, 18, 19: Optional Adapters to bespecified with the order. For detailsplease refer to the specific orderinginformation.kits.pm6* The resolution is to be specified and whether inch or metric gauges. For details please refer to Section II.2 “Connector Interface Gauges”, page 75 f.f.Spectrum Elektrotechnik GmbH P.O. Box 45 05 33, 80905 Munich, Germany Tel. (89) 354 804-0, Fax (89) 354 804-90 (Country Code: 49)17