DC Genset / Watermaker Manual - Balmar

1. Exhaust heat detector. 2. Block temperature sensor. 3. Oil pressure sensor.Automatic AlarmShutdownAll sensors on the engine open their circuits in the alarm state, which will automaticallyshut the engine down by discontinuing electrical current to the fuel solenoid.The three automatic shutdown sensors include: 1.) Exhaust Water Inject Elbow Heatdetector; 2.) Engine Block Temperature Sensor; and, 3.) Oil Pressure Sensor.Exhaust water inject elbow heat detector (1)Located at elbow of engine exhaust pipe.Engine block temperature sensor (2)Located on the front of the engine, forward of the injector pump near the thermostat.Oil pressure sensor (3)Located under injector pump and aft towards fly wheel.After the genset has run for a few moments, turn off the engine and inspectfor raw water, fresh water, and oil leaks.Activation of Charging SystemAfter the initial inspection, test run and post-run inspection are complete, start the gensetengine. Turn alternator toggle switch to 'ON' position at panel. Verify that the LED displayon your voltage regulator is cycling through the basic display. (Display should indicatemanufacturer, model number, program number, battery type, charging stage, "real time"battery voltage, and target/calculated voltage. Values will vary based on your programselection. See additional details in the accompanying regulator manual.)After a 45 second delay, the regulator should indicate that voltage is ramping up atalternator outputAfter 1 minute of ramp up, insure that battery voltage is stabilized at proper level(assuming batteries are not deeply discharged or large load is not applied).Verify that CV display (regulator calculated voltage) and BV display (battery voltage) atregulator are nearly identical.- 22 -