DC Genset / Watermaker Manual - Balmar

5. Once aligned, insert the 30mm Capscrews into the three radial cavities in theLovejoy. Tighten each capscrew just far enough to ensure proper threading untilall screws are properly aligned and threads are started.6. When all three capscrews are in place, Tighten to 20 ft.lb. It may be necessary,once all capscrews are in place, to turn the crank pulley on the engine to accessall of the capscrews for torqueing.7. Inspect the Lovejoy forproper alignment asillustrated at right.Loosen capscrews andre-tighten, if necessary,to ensure that theLovejoy is free fromdistortion.8. Re-check torque.Shows correct and incorrect radial coupling alignment.9. Replace Cat Pump platform.10. Re-connect wiring connections at alternator as described in the alternator manualincluded in the genset instructions.Notes:- 6 -