User Guide Product(range) - Neopost

• confirm the settings by pressing “OK” whichwill get you back to the “job settings” menu.The fold length of the first fold can be minimally 75mm (2.95 inch) and maximally the length of thelongest document used minus 100 mm (4.0 inch).The fold length of the second fold can be minimallythe length of the first fold plus 25 mm (1.0 inch)and maximally the length of the longest documentused minus 75 mm (3.0 inch).5.4 Double Feed ControlWhen the “DFC settings” menu is selected thefollowing functions are available (see figurebelow):6.1 AdjustmentsReading head positionThe reading head must be placed according tothe (horizontal) position of the printed marks onthe documents. To adjust the reading head,proceed as follows:• take a document with a reading code,• fold the document on the first mark (see nextfigure).5.5 OMR settings (Optional)Refer to the chapter "Optical Mark Reading".5.6 Job nameThis menu shows the following functions (seefigure below):• hold the document onto the ruler (see nextfigure),• adjust the reading head A according to themiddle of the marks,• divide the paper guides B along the width ofthe document.When the reading head is adjusted it is possiblethat some paper guides B have to be removedand replaced on the other side of the readinghead.6. OPTICAL MARK READING(OPTIONAL)The folding and inserting system can beequipped with Optical Mark Reading. With thisoption the system reads optical marks that havebeen specially printed on the documents. Thiscode contains information about the processingof the documents. A set can have a varyingnumber of sheets. The document with theprinted code is placed in the upper feeder.The replacement procedure is the reversal ofthe removal procedure.16