Service Manual - TOSHIBA TEC store

More documents

Recommendations

Info

2. MAJOR UNIT REPLACEMENT EO18-33024(Revision Date: Mar. 17, 2009)2.7 Replacing the Stepping Motor2.5 Replacing the Stepping Motor1) Remove the Right Cover, Left Cover and Front Cover. (Refer to Section 2.1 Replacing the CPU PCBoard.)2) Remove the two Gears.3) Remove the two screws.Stepping MotorSMW-2x6 ScrewGearNOTE: When replacing the gear, apply a small amount of Floil (8mm 3 ) to each Gear Stud with a toothpick, etc.by drawing a line around the part as shown below.Gear Stud (2 places)FLOILGear Stud2-12
2. MAJOR UNIT REPLACEMENT EO18-330242.7 Replacing the Stepping Motor4) Disconnect the Connector from the Drive PC Board.5) Remove the Stepping Motor.Stepping MotorConnectorDrive PC Board6) Replace the Stepping Motor with a new one, then reassemble in the reverse order of removal.2-13
Page 2 and 3: WARNING!Follow all manual instructi
Page 4: 1. UNPACKING EO18-330241.1 Procedur
Page 8 and 9: 2. MAJOR UNIT REPLACEMENT EO18-3302
Page 14: 2. MAJOR UNIT REPLACEMENT EO18-3302
Page 30: 3. TROUBLESHOOTING EO18-330243. TRO

Service Manual - TOSHIBA TEC store

Create successful ePaper yourself

Delete template?

Save as template?