Ademco Vista 10P - enTouch

7URXEOH&RQGLWLRQV&RQWLQXHGWords or letters in parentheses ( ) are those that aredisplayed on Alpha Display keypads.Other TroubleDisplays* Any “beeping” thataccompanies a troubledisplay can be stoppedby depressing any keyon the keypad or byentering an OFFsequence (code + OFF)** Not all systems usewireless sensors.COMM. FAILURE(or FC)SYSTEM LO BAT(or BAT with nozone No.)Indicates that a failure has occurred inthe telephone communication portion ofyour system.CALL FOR SERVICE.Indicates that a low system batterycondition exists. Display isaccompanied by "beeping"* at thekeypad. If this condition persists formore than one day (with AC present),CALL FOR SERVICE.LO BATIndicates that there is a low battery+ zone descriptor condition in the wireless transmitter**(or BAT withnumber displayed (00 is RF keypad).zone No.)Accompanied by a single "beep"* (aboutonce every 40 seconds) at the keypad.Either replace the battery yourself, orCALL FOR SERVICE. If the battery isnot replaced within 30 days, a CHECKdisplay may occur.Rcvr Jam(or CHECK 90)MODEM COMM(or CC)BELL FAILURE(or CHECK 70)Wireless part of the system is experiencingRF interference which may impedereception from wireless sensors.**Indicates that the control is on-line withthe Central Monitoring Station's remotecomputer.The control will not operate while on-line.Wait a few minutes — the display shoulddisappear.Indicates that the wiring connection tothe external sounder is at fault (open orshorted). Accompanied by “beeping” atthe keypad. CALL FOR SERVICE.– 38 –