CIMCO CNC-Calc 2 Tutorial

More documents

Recommendations

Info

Now open the CAD drawing Pocket with semi circle island.cdd.Your screen should now look like this:Figure 7.4 CAD drawing 'Pocket with semi circle island.cdd'.In the above drawing (Figure 7.4) the middle area between the outer contour and thesemi circle island should be milled down to a depth of 20 mm. (Z = -20 mm.) using aØ20 mm. endmill. The island is to be finished on the sides, but should otherwise beleft as is.Verify that the part is placed in the coordinate system as it will later be placed in themachine during the actual operation. Otherwise rotate it to the desired orientation.3
Generating toolpath from geometryThe toolpaths can now be generated from the geometry.Figure 7.5 Selection of NC format.Select the the new program's NC format (e.g. ISO Milling or Heidenhain).Select the desired operation type. Selection can be done from the <strong>CNC</strong>-<strong>Calc</strong> menu orthe corresponding icon, as shown below.Figure 7.6 Selection of operation type – here, Pocket Milling.4
Page 1 and 2: www.cimco-software.comCIMCO CNC-Cal
Page 3: Before you startWhen a new part is
Page 7 and 8: Figure 7.8 The Roughing parameters
Page 9 and 10: Now select the contours.Start with
Page 11 and 12: Figure 7.14 NC codes for the comple

CIMCO CNC-Calc 2 Tutorial

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?