7872 Scanner Upgrade to Scanner/Scale

7872 Scanner Upgrade to Scanner/ScaleInstall the Top PlateTop PlateWith Weigh Bar17980The Top Plate sits on four posts that are connected to the H-Bar and is installed invarious ways depending on its construction.Top Plate with No Lifting Device1. Using both hands, position the Top Plate over the front of the 7872 and lower theback of the Top Plate until the two back supporting posts are in the notches in theTop Plate.2. While holding the Top Plate with one hand, grasp the front with the other.Carefully lower the Top Plate until it is sitting on the two front supports. You mayneed to drop it when it gets too close to the NCR 7872 for you to keep your handunder it.Top Plate with Weigh Bar1. Using both hands, position the Top Plate over the front of the 7872 and lower theback of the Top Plate until the two back supporting posts are in the notches in theTop Plate.2. While holding the Top Plate with one hand, grasp the Weigh Bar with the other.Let go of the Top Plate, holding it only by the Weigh Bar, and lower the front untilit is sitting on the two front supports.3. Push the Weigh Bar down until it is level with the top surface of the Top Plate.Note: This does not latch the Top Plate down, it just stows the Weigh Bar belowthe surface of the Top Plate.497-0422375 Release A 08/01 19 of 20