CP3800DW User Manual English - Mitsubishi Electric Europe Benelux

More documents

Recommendations

Info

Setting i g Up the ePrintert r7. Remove the tape, and advance the roll as indicated by the arrow. Set the end of the paper about 5mm beyondthe roller. When doing this, insert the paper straight along the seal. If it isn’t inserted straight, the paper willbe crooked, which could cause white line on the edges of the print, ribbon wrinkles, and register slippage.Path of the paperAs seen from above○ ×8. Set the paper cassette into the printer.13
Setting nUp the Printer9. Turn the paper in the direction of the arrow. When it is advanced enough, the buzzer will beep, and theflashing LED (orange) will go out.It is easier to set if the paper is turned while securing the holder with one hand.10. Set the scrap box, and close the cover.The printer will not operate without the scrap box.If the mechanism unit is closed without the scrap box attached, there will be a “No Scrap Box Error”, and theLED will flash (red).CAUTION・ The printer will not operate without the scrap box attached.・ When the scrap box is removed, do not insert your fingers in the cutter at the top.They could be cut or severed.・ As prints are cut, the scrap box fills with scrap paper. Be sure to empty it when you change the paperand ribbon. If it becomes over-filled with scraps, it could cause problems with the printer.14
Page 4 and 5: ●American, Canadian UsersCord set
Page 6 and 7: ItalianCon la presente Mitsubishi E
Page 9 and 10: Names of ComponentsSetting i g Up t
Page 11 and 12: Paper and RibbonSetting i gUp the e
Page 13: Setting nUp the Printer5. Install t
Page 17 and 18: Error DisplaysTrouble-shootingPower
Page 19 and 20: Trouble-shootingos og2. Remove the
Page 21 and 22: Trouble-shootingc. If the printer i
Page 23 and 24: SpecificationsModelCP3800DWPrint ty

CP3800DW User Manual English - Mitsubishi Electric Europe Benelux

Create successful ePaper yourself

Delete template?

Save as template?