MODEL V1433XL, V1433 MODEL V1833XL, V1833 - MinnPar

ELECTRICAL SYSTEM DESCRIPTIONThe following is a detailed description of the electrical system used on the CONDOR® modelV14331XL, V1833IXL scissor, and how it designed to operate. To assist in understanding the system,this description should be used in conjunction with the electrical schematics found at the end of thissection.GENERALThe CONDOR® model V14331XL, V1833IXL uses a 24 volt direct current (DC) electricalsystem consisting offour, 6 volt DC batteries, an electric motor to drive the hydraulic pump, and variouselectrical controls to operate the system. Included in this system description is a Machine Optionssection, describing options which are available on the model V14331XL, V18331XL. All of the optionscontained in this description are electrical only, and do not affect the hydraulic performance of themachine.BATTERIESThe model V14331XL, V1833IXL scissor uses four, 6 volt DC batteries, each having a 235 amphour capacity. There are two batteries on each side of the belly pan nearest the steer axle. The fourbatteries are connected in series, combining their voltage, to make up the 24 volt DC system. The batteriesare of the wet-cell type, and when filled with electrolyte, each battery weighs 661bs. More informationon batteries in general can be found in the Battery Service Section beginning on page 23.BATTERY CHARGERThe battery charger has a 25 amp @ 24volt DC nominal rating, and operates off of a 115volt alternating current (AC), 160 Hz, 8 ampinput. The charger features contains an ammeterfor reading the DC amp output, and two LEDstatus indicator lights; a red LED indicates thecharger is on, charging, while a green LED indicatesthe charging is complete. The charger islocated on the right side of the belly pan, betweenthe pump/motor assembly and batteries (See FIG.9). More detailed information of the charger canbe found in the Battery Charger TroubleshootingGuide beginning on page 43.Main ManifoldAssemblyGround ControlsFIG. 9CIRCUIT BREAKERIFUSELocated below the control selector switch on the lower control box (see FIG. 11), is a 15 ampfuse. This circuit fuse protects all the machine control circuits.MANUAL 92370-002November 1997