MODEL V1433XL, V1433 MODEL V1833XL, V1833 - MinnPar

More documents

Recommendations

Info

EDLOW VOLTAGE BATTERYPROTECTION SYSTEM (OPTION)This option prevents operation when thebatteries are in a low voltage condition. It becomesenergized whenever the control selectorswitch is in either "UPPER" or "LOWER" position(lower emergency stop button must be pulledout). While energized, the module monitors thebatteries' voltage level, and will prevent the pumpmotor contactor from being activated once thebattery voltage reaches 12.5% undervoltage, orapproximately 21 volts. This condition must bepresent for 21 seconds to activate the interruptsystem. Terminals 3 & 4 of the module arenormally closed contacts which complete theLow Volt Override Pushbutton(w/Amber Indicator Lamp)SlopeAlarmSignal HornPushbutton(white)~~3"- Cable Harness PlugFIG. 14pump motor contactor circuit, and it is these contacts which are opened during a low voltage condition.Terminal 7 ofthe module is the battery input voltage, while terminal 6 is machine ground. Terminals 1& 2 are normally open contacts which close during a low voltage condition and turns on an amberindicator light (pushbutton) at the upper control box. The system can be overridden by pressing thepushbutton on the side ofthe upper control box (See FIG. 14), which energizes terminal 5 of the module.However, the override will only allow three repeated by-pass cycles of2 minutes 30 seconds each. TheLVI module will reset when the battery voltage reaches approximately 25.5 volts during re-charging.Once the batteries have been properly charged and the L VI module has automatically reset, theCONDOR® can be operated once again.TRAVEL ALARM (OPTION)This option indicates forward or reverse drive (travel) of the machine. The alarm signal isactivated by the deceleration valve circuit since the deceleration valve is always energized during bothforward and reverse drive.DESCEND ALARM (OPTION)This option indicates descent (lowering) of the platform. The alarm signal is activated by theholding valve circuit, which is energized when lowering the platform.MOTION ALARM (OPTION)This option indicates forward or reverse drive, and raising or lowering of the platform. The alarmsignal is activated from two different circuits; one energizes the pump motor contactor, and the otherenergizes the holding valve for platform lowering (pump not running). A diode is used in each circuitto prevent unintended feedback.HOUR METER (OPTION)This option is to record the "run time" of the machine for maintenance scheduling, rental usage,etc.. The meter runs only when the pump motor contactor is energized (pump running); therefore, themeter does not run when the machine is sitting idle, or when the platform is being lowered.MANUAL 92370-002November 1997
~3 ______________________________________________ ~H~NElectrical Schematic•r3~ _________________________________________________________ Rrn--{5·}-B_~ ______ ~14 WHTSLoPE SENSOR OPTIONSLOPE ALARIA oPTION3 .f.. WH1~2. BUT. SEE NOTE 3t=-----3~------~----------------~A~----~3-POSSELECTOR+,3,,-_...:U1';;..;,.;PE:;;R'-J> (~ SD..l.-,SDLOWERSIGNAL oPTIONLOW VOLT OPTION (SENSOR)STROBE LIGHT oPTIONSA TTERY CONDITIONINDICA TOR oPTIONSA TTERY DISCONNECTKEY SWITCH OPTIONfOUR 6VOC SA TTERIESPLAlFORM6C· ~ B UPPUMP MOTORPUMP MOTOR CONTACTOR5CI PLA~=~9~ ___ ~_~-+ _____ ~ _______ ~_~~_~BCHOUR METER OPTIONMOTION ALARM oPTIONVALVE ON LIFT en7DESCEND ALARU OPTIONRIGHT(STEER VALVE)LEftFORWA.RD(DRIVE VALVE)REVERSEGREEN.f..~ PLA ~g"W::3A ENAB~: :LArr~U8D3C ~ 8 uP~--------~----------~----------~~~3B 10,3-POSSPEroSELECTOR,I3B I 11~W~ ____ ~~~~~~~ ____ ~+{~2'H-__________ ~III1fAS££ NOTE 1TRAVEL ALARM OPTIONDECELERATION VALVEun PLATFORM.(SELECTOR VALVE)fAST DRIVE SPEEDCREEP DRIVE SPEED VAL 'IE3B "--"""-'12"-________________________________________________ -o.J/r __
Page 1 and 2: TIME CONDOR CorporationSELF-PROPELL
Page 10 and 11: F. DECK EXTENSIONB. RAMP MEmOD•Li
Page 12 and 13: NOTES•MANUAL 92370-001November 19
Page 14 and 15: APPENDIX: DECALS ILLUSTRA nON•ITE
Page 16 and 17: APPENDIX: DECALS ILLUSTRATION•3I
Page 18 and 19: APPENDIX: DECALS ILLUSTRA nON2011 0
Page 20 and 21: INTRODUCTIONiThe primary purpose of
Page 22 and 23: iiiCondor® Self-Propelled Booms an
Page 25 and 26: D. PROCESSING OF WARRANTY CLAIMDuri
Page 28 and 29: • NOTESMANUAL 92370-002November 1
Page 30 and 31: • RECOMMENDEDTOOL LISTThe followi
Page 32 and 33: •This Page Intentionally Left Bla
Page 34 and 35: • PUMPIMOTORThe pump wall motor a
Page 36 and 37: •DRIVEFUNCTION (cont'd)When the s
Page 38 and 39: • Toaid troubleshooting, some oft
Page 40 and 41: This Page Intentionally Left BlankM
Page 42 and 43: • PUMPMOTORThe CONDOR® model V14
Page 44 and 45: NOTESMANUAL 92370-002November 1997
Page 49 and 50: •BATTERY SERVICING TOOLSUse prope
Page 51 and 52: The average state of charge ofthe c
Page 53 and 54: DETERMINING CAUSES OF BATTERY FAILU
Page 55 and 56: STEP 1STEP 2II OBVIOUS DAMAGE III R
Page 57 and 58: PREVENTIVE MAINTENANCE•In conjunc
Page 59 and 60: •PREVENTIVE MAINTENANCE INSPECTIO
Page 61 and 62: PREVENTIVE MAINTENANCEDAILY INSPECT
Page 63 and 64: B. ARMSTACK•Visual Inspection:Lif
Page 65 and 66: PREVENTIVE MAINTENANCE50 HOUR INSPE
Page 67 and 68: HYDRAULIC FLUID SPECIFICATIONSFORCO
Page 69 and 70: TROUBLESHOOTING GUIDE115 VAC BATTER
Page 71 and 72: CAUTIONDO NOT charge batteries with
Page 73 and 74: •Connect the black lead of the po
Page 75 and 76: SECTION 3 -AMMETER READS 30 AMPS FO
Page 77 and 78: •If the charger remains on longer
Page 79 and 80: APPENDIX AA div. of TIME Manufactur
Page 81 and 82: ATTENTIONMANUAL OF RESPONSIBILITIES
Page 83 and 84: RESPONSIBILITIES MANUALReprint from
Page 93 and 94: RESPONSIBILITIES MANUAL(9) Outrigge
Page 97 and 98:
TIME CONDOR CorporationSELF-PROPELL
Page 99 and 100:
iiCONDOR® SERVICE INFORMATION1. If
Page 101 and 102:
•FIGUREDESCRIPTION PAGE8.1 ......
Page 103 and 104:
• FIGURE B-Howto Order Parts1. Wh
Page 105 and 106:
• FIGURE 1.1: FinalInstallation74
Page 107 and 108:
• FIGURE 1.2: Final InstallationN
Page 109 and 110:
• FIGURE l.3:DecalInstallation•
Page 111 and 112:
• FIGURE2.1:CaniageAssemblyTOPVIE
Page 113 and 114:
• FIGURE 2.2: Steer CylinderITEM
Page 115 and 116:
• FIGURE 2.4: Hub AssemblyITEM PA
Page 117 and 118:
e FIGURE2.6: RearHubAssemblyITEM PA
Page 119 and 120:
•FIGURE3. 1 : Hose InstallationFR
Page 121 and 122:
• FIGURE4.1: Belly Pan AssemblyRE
Page 123 and 124:
• FIGURE 4.2: Cable KitGROUNDSTUD
Page 125 and 126:
• FIGURE4.3:Motor&PumpAssembly7~
Page 127 and 128:
· ... ,• FIGURE4.5:Motor24VDCAss
Page 129 and 130:
": .. .::..::. .....• FIGURE 4.6:
Page 131 and 132:
• FIGURE 4. 8: Valve AssemblyAI"
Page 133 and 134:
•This PageIntentionallyLeftBlank.
Page 135 and 136:
...........,I1-GRN-ORN=!!:!!_SLUI-I
Page 137 and 138:
,rl{i§!~ ...PROP DRIVEOPTIONCABLE/
Page 139 and 140:
• FIGURE6.1:BoxAssembly-LowerCont
Page 141 and 142:
IIit-.. r;(> ;~.. .~r:.. ~~:...'f:'
Page 143 and 144:
.~i·
Page 145 and 146:
eI"I'j- ~f~If~_i§~;505012 GA11l1A1
Page 147 and 148:
• FIGURE 7.1: ArmstackAssembly-V1
Page 149 and 150:
8f~r:_I;:~~...REF -BRG BLOCK IS IN
Page 151 and 152:
• FIGURE 7.2: AnnstackAssembly-Vl
Page 153 and 154:
,~-~!~...REF PADS & PIN ARE IN FINA
Page 155 and 156:
• FIGURE 7.3: AnnstackLiftCylinde
Page 157 and 158:
• FIGURE7.5:~kLi:ftCylinderAssemb
Page 159 and 160:
FIGURE 7.7: Manifold AssemblyITEM P
Page 161 and 162:
•FIGURE 7.9: HamessAssemblyC;~C~I
Page 163 and 164:
.,This Page intentionally left blan
Page 165 and 166:
FIGURE8.l: Platform Installation-Vl
Page 167 and 168:
FIGURE 8.2: PlatfonnInstallation-V1
Page 169 and 170:
FIGURE 8.3: Upper Control Box Assem
Page 171 and 172:
FIGURE 8.4: Upper Control BoxAssemb
Page 173 and 174:
CONDOR SERVICEPART NUMBER DESCRIPTI
Page 175 and 176:
FIGURE 8.4: Upper ControlBox Assemb
Page 177 and 178:
FIGURE 9.1: IlOVoltExtensionToPlatf
Page 179 and 180:
FIGURE 9.3: MotionAlann(Option) •
Page 181 and 182:
FIGURE 9.5: Descend Alarm (Option)
Page 183 and 184:
FIGURE9.7:SlopeAlann(Option)•ITEM
Page 185 and 186:
FIGURE 9.9: Battery Condition Indic
Page 187 and 188:
FIGURE9.11:LargerBatteriesIPOS(XL-O
Page 189 and 190:
CONDOR® MODEL V14331XL, V18331XLVE
Page 191 and 192:
__ '- __ '-' " -''-~ I ._ ..... ,
Page 193 and 194:
OWNERS MANUAL24 VoltFully Automatic
Page 195 and 196:
This battery charger IS for use on
Page 197 and 198:
WIRING DIAGRAME:..ECTRONIC TIMER1 4
Page 199 and 200:
OPEN CIRCUIT TRANSFORMER TESTFailur
Page 201 and 202:
SECTION 1 -CHARGER DOES NOT TURN ON
Page 203 and 204:
OPEN C:'PAC:TOR-When me onmme!er le
Page 205 and 206:
If the cnarger remarns on longer tl
Page 207 and 208:
~JO. 7·j24EatonHydraulicsDivision2
Page 209 and 210:
3 DisassemblyCleanliness IS extreme
Page 211 and 212:
Check all mating surfaces. Replace
Page 213 and 214:
7 . Reassembly40 I nstatl the tie b
Page 215:
l 3 14 ~Tf-j,ORN....."..-Q WHITE.3
show all

MODEL V1433XL, V1433 MODEL V1833XL, V1833 - MinnPar

Create successful ePaper yourself

Delete template?

Save as template?