Synchronous servomotors DBL/DBK - BIBUS SK, sro

More documents

Recommendations

Info

Installation / Setup 01/2004 Kollmorgen II.2.1.2 Wiring diagram for encoder motors - A.4.043.1/02 18 Servomotors DBL/DBK
Kollmorgen 01/2004 Installation / Setup II.3 Setup The procedure for setup is described as an example. A different method may be appropriate or necessary, depending on the application of the equipment. Only specialist personnel with extensive knowledge in the areas of electrical engineering / drive technology are allowed to commission the drive unit of servoamplifier and motor. Caution! Check that all live connection points (terminal boxes) are safe against accidental contact. Deadly voltages can occur, up to 900V. Never undo the electrical connections to the motor when it is live. The residual charge in the capacitors of the servoamplifier can produce dangerous voltages up to 5 minutes after the mains supply has been switched off. The surface temperature of the motor can reach 100°C in operation. Check (measure) the temperature of the motor. Wait until the motor has cooled down below 40°C before touching it. Make sure that, even if the drive starts to move unintentionally, no danger can result for personnel or machinery. � Check the assembly and orientation of the motor. � Check the drive components (clutch, gear unit, belt pulley) for the correct seating and setting (observe the permissible radial and axial forces). � Check the wiring and connections to the motor and the servoamplifier. Check that the earthing is correct. � Test the function of the holding brake, if used. (apply 24V, the brake must be released). � Check whether the rotor of the motor revolves freely (release the brake, if necessary). Listen out for grinding noises. � Check that all the required measures against accidental contact with live and moving parts have been carried out. � Carry out any further tests which are specifically required for your system. � Now commission the drive according to the setup instructions for the servo amplifier. � In multi-axis systems, individually commission each drive unit (servoamplifier and motor). Servomotors DBL/DBK 19
Page 1 and 2: www.DanaherMotion.com Synchronous s
Page 3 and 4: Kollmorgen 01/2004 Contents Content
Page 5 and 6: Kollmorgen 01/2004 Important notes
Page 7 and 8: Kollmorgen 01/2004 General I Genera
Page 9 and 10: Kollmorgen 01/2004 General I.5 Stan
Page 11 and 12: Kollmorgen 01/2004 General I.6 Opti
Page 13 and 14: Kollmorgen 01/2004 Installation / S
Page 15 and 16: Kollmorgen 01/2004 Installation / S
Page 17: Kollmorgen 01/2004 Installation / S
Page 21 and 22: Kollmorgen 01/2004 Technical data I
Page 23 and 24: Kollmorgen 01/2004 Technical data D
Page 25 and 26: Kollmorgen 01/2004 Technical data T
Page 69 and 70:
Kollmorgen 01/2004 Appendix IV Appe
Page 71 and 72:
Kollmorgen 01/2004 Appendix IV.3 In
show all

Synchronous servomotors DBL/DBK - BIBUS SK, sro

Create successful ePaper yourself

Delete template?

Save as template?