Installation and User Manual - AJ Madison

Electrical Connectioncooktop electrical characteristics are:Operating voltage................................................... 240 V~ 60 HzMaximum power output .............................................. 7200 W 30AConnect to .............. 240 V, 60 Hz, 2 Pole+G, 40 A minimum supply,(3 conductors #10 AWG)Electrical wiring informationAn adequate electrical supply must be providedfor this unit. All wire connections andgrounding must be done in accordance withlocal electrical codes, or if these codes arenot established, then with the National ElectricalCode, ANSI/NFPA No. 70 in the US , orwith the Canadian Electrical Code, CAN/CSAC22.1, in Canada.•240 VConnect the 3 wires as per the followingcolour codeGreenThis unit comes equipped with three connectionwires in a flexible conduit. The conduitmust be routed and properly connected to anapproved, owner-supplied, electrical, walljunction-box. An approved connector must beused for connecting the conduit to the junctionbox. A three wire, 2 poles, 240 V, 60 Hzservice with minimum 40 A circuit protectormust be provided. The red and the black wirefrom the unit are to be connected to the service(”hot”) wires, and the green wire is to beconnected to the ground conductor.The circuit protector for the unit should beproperly marked inside electric panel and anybodyusing the unit, or technician servicingthe unit, should be advised of circuit protector’slocation, so that the power to the unit canbe disconnected when necessary.Once the unit is properly fitted and connectedto the electrical power supply, turn the unit onto ensure that all elements and controls areoperating well.Note that your unit is designed for a stabileand steady 240 V supply and the manufacturer,its distributors and dealers cannot be heldRedBlackPhase 2LPhase 1LEarthresponsible for any unit malfunction due to aninadequate electrical supply (inadequate cablesize, low voltage, power surge etc). Furthermore,if your residence has only a 208 Vsupply system, and if the voltage frequentlyfluctuates, your cooktop may not function properlyIt is recommended that the connection toelectrical supply is done by a qualified electrician.If there is any visible physical damage on theconduit and the wires, the unit must not beconnected to the mains. A qualified electricianor approved service agent should be called into replace the wires and the conduit.8