Mitsubishi DX-TL5000E User Manual - SLD Security ...

Using the cascade functionCascadeThis function is used to observe the pictures supplied fromthe camera connected up to 16 DX-TL5000E via onemonitor. The multiplexer function of all the connected DX-TL5000E and PTZ of all the connected cameras can becontrolled by the master recorder.• During cascade mode, the picture from the slaverecorder is displayed on the monitor connected toVIDEO CASCADE OUT connector of the masterrecorder.• The cascade function of audio is available whenattaching the optional audio interface board DX-SC5.• Before using the cascade function, check thefollowing:• The recorders are connected via the RS-485terminal. Cascade connection for audio and videois made.• The password lock of level 2 or higher is turned onfor the slave recorders.• The ID number of the master recorder is set to 01and that of the slave recorders are set to any numberfrom 02 to 16.step1.Press the PTZ button for more than 2 seconds.• The unit switches to the cascade mode.• On the slave recorder, the status of the cascademode is shown on the LCD display.During cascade mode (during connecting):01-01-2004 00:00:00CASCADE ONDuring cascade standby mode:01-01-2004 00:00:00CASCADE MODEstep2.Press the camera number button corresponding tothe ID number of the slave recorder to be controlled.• Press the camera number button within 3 secondsof switching the unit to the cascade mode.• The picture from the selected recorder isdisplayed on the monitor connected to the VIDEOCASCADE OUT terminal of the master recorder.By using the buttons of the master recorder, themultiplexer function of the slave recorder can beoperated. And also by operating PTZ of themaster recorder, the camera connected to theslave recorder can be controlled.• The ID number of the slave recorder controlledappears on the LCD display on the front panel ofthe master recorder.01-01-2004 00:00:00CASCADE ID02It is also displayed on the monitor screen.step3. To control the other recorder, repeat steps 1 and 2above.• Press the PTZ button for more than 2 seconds tocancel the operation of the slave recorder anddisplays the picture supplied from the cameraconnected to the master recorder again.12••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••