CONTACT MEASURING - Teknikel

13 Digitamic digital comparator. ConfigurationThe Digitamic digital reference gauge is fully programmable using three dataentry keys :Display.. Actual dimension or difference from a floating zero.. metric or inch.. Dimension status : within specification, oversize or undersize.. Reversible display.Measurement.. Simple or differential.. Dynamic gauging with “hold” feature : max, min, max-min, (max+min)/2.. Upper and lower limits.. Zero offset.. Compensation for surface finish.. Memorization of measurement result with auto reset at each gauging cycle.Mastering.. With one master anywhere within part specification limits.. With one set of min-max masters, the Digitamic computes the gainautomatically based on certified values of the masters.. Technical characteristicsThe module aspectof the Digitamic simplifiesthe connection and dataexchange between unitsand/or an external network.Probe TypesProbe connectionMeasuring rangeDigital displayProtectionOperating temperatureElectrical power supplyStackingNetworkingLVDT, 1 /2 bridge, microprobe6-pin socketFrom ± 0.010 to ± 10 mm8 digitsIP65+5°C to +50°C220/110V AC8 units with electrical supplyRS232Digitamic Description Part numberRemarksThe single DigitamicSingleLVDT probe,half bridge probe,microprobeE500001/920E500001/921E500001/922can be used by itself oras a head of battery.It is equipped with anelectrical supply.StackableLVDT probe,half bridge probe,microprobeE500001/925E500001/926E500001/927The stackable Digitamiccan not be used itself.An single Digitamicis needed for.