Light Vehicle Inspection Manual (PDF 7MB) - Transport

Section 1:Vehicle IdentificationAustralian Design Rules relevant to this section:ADR 61/00. /01. /02 Vehicle MarkingsOBJECTIVE: To ensure that vehicle being inspected is authentic and correctly identified.1.1 Check the identity of the vehicleReason for Rejectiona) No VIN/Chassis number present.b) VIN/Chassis on compliance plate differs from that stamped into body or chassis.c) VIN/Chassis number has been altered or tampered with or not authentic.d) Engine number has been altered or tampered with.e) No engine number present.f) A motor vehicle other than a motor- cycle, manufactured after August 1972 that is not fitted with an Australiancompliance plate and has not been previously registered in Australia.g) A motor- cycle manufactured after June 1975 that is not fitted with an Australian compliance plate and has notbeen previously registered in Australia.h) A trailer manufactured after December 1988 that is not fitted with an Australian compliance plate and has notbeen previously registered in Australia. *i) Vehicle manufactured prior to August 1972 that has not been previously registered in Australia.Note: An AIS may pass a new (not previously registered) light trailer for registration when it has been inspected and found to beroadworthy by obtaining a VIN and fitting a recognised compliance plate in accordance with procedures set out in the AISmanual.Light Vehicle Inspection ManualVersion 11, December 2013 15