Light Vehicle Inspection Manual (PDF 7MB) - Transport

Section 8:LightingAustralian Design Rules relevant to this section:ADR 1 Reversing lamps.ADR 6 Direction indicator lampsADR 13 Installation of lighting on other than L group vehiclesADR 19 Installation of lighting on L group vehiclesADR 45 Lighting not covered by ECE regulationsADR 46 Head lampsADR 47 Reflex reflectorsADR 48 Rear registration plate illuminating devicesADR 49 Front and rear position (side) lamps, stop lamps and end-outline marker LampsADR 51 Filament globesADR 60 Centre high mounted stop lampsOBJECTIVE: To ensure that all lights, reflectors and other electrical lighting components as required by prescribed standardsare operational.8.1 Visually inspect the compulsory reflectors fitted to therear of the vehicleReason for rejectiona) Red reflector(s) are damaged, discoloured or missing (note: reflectors may be incorporated in the lampassembly).8.2 Visually inspect and check the operation of all lightsfitted to the vehicleReasons for rejectiona) any of the following lights do not work or has incorrect colour.(i) headlight (high/low beam) (white)front park or side lights (white)tail lights (red)brake light(s) (red)turn signal indicator lights (yellow)clearance lights (trucks and cycle type vehicles only) (front: yellow/white, side: yellow, rear: yellow/red)number plate light (white).b) any rear light other than a reversing light is in a condition or damaged to the extent that white light shows to therear of the vehicle.c) any yellow clearance light or front turn signal is damaged so that it shows white light.Light Vehicle Inspection ManualVersion 11, December 2013 37