Light Vehicle Inspection Manual (PDF 7MB) - Transport

More documents

Recommendations

Info

8.7 Visually inspect the headlightsReasons for rejectiona) headlight reflector is tarnished or peeling to the extent that headlight performance is impaired.b) headlight lens is incomplete.c) headlight assembly is not secured.d) headlight is water damaged or has incorrect beam pattern.e) the headlight lens shows deterioration reducing the effectiveness of the headlight from initial manufacture.Note:For further information on lighting requirements, refer to Appendix J’ Lighting Standards’ and Appendix K ‘Headlamptesting Screens’.40 Light Vehicle Inspection Manual Version 11, December 2013
Section 9:Engine Compartment & DrivelineADRs applicable to this section:ADR 42 General safety requirementsADR 79 Emission Control for light vehiclesADR 80 Emission control for Heavy VehiclesADR 83 External NoiseOBJECTIVE: To ensure that engine and driveline components are compliant with the regulations and operate in a safe manner.9.1 Visually inspect the engine, transmission and drivelinefor oil/fluid leaks.Reasons for rejectiona) oil is leaking from the engine, gearbox, differential, or from any joint or seal onto any of the following.1. brake friction surfaces.2. the exhaust system.3. oil or fluid dripping onto the road surface, at a rate of more than one drop every 30 seconds.b) Evidence of oil or fluid leaking from any brake or power steering component.9.2 Visually inspect engine, transmission and drivelinecomponentsReason for rejection:a) any engine or transmission mounting is cracked or not secured.b) rubber components are severely perished, broken or deteriorated.c) fasteners on couplings in the driveline are cracked, loose or missing.d) any transmission drive shaft is bent, damaged, loose or noticeably misaligned.e) any universal or constant velocity joint has excessive wear, is misaligned, seized, is not securely attached, or has adamaged or missing boot.f) where an automatic transmission is fitted, the engine can be started in any gear position other than neutral orpark (ensure that brakes are applied during this test).g) any modifications to engine, transmission and driveline components that does not have modification approvalNOTE: For further information on modifications, refer to Appendix O modification brochure9.3 Visually inspect the electrical systemReasons for rejection:a) A battery (s) is not secured in a cradle or carrier using hold down clamps, is cracked, leaking or has missing caps.b) A battery mounted in the interior of a bus is mounted to allow acid or fumes to come into contact withpassengers or goods.Light Vehicle Inspection ManualVersion 11, December 2013 41
Page 1 and 2: Light VehicleInspection ManualTasma
Page 3 and 4: ContentsVery Important Advice 9Admi
Page 5 and 6: 10.5 Visually inspect direct filled
Page 8 and 9: 8 Light Vehicle Inspection Manual V
Page 10 and 11: 10 Light Vehicle Inspection Manual
Page 12 and 13: Tasmanian Inspection Manual for Lig
Page 18 and 19: 2.2 Inspect the condition of visibl
Page 22 and 23: NOTES:(1) A 50 mm ball coupling is,
Page 24 and 25: 4.2 Visually inspect all steering c
Page 28 and 29: l) for a passenger car with 4 or mo
Page 30 and 31: Reason for rejectionNote:a) The are
Page 32 and 33: first line delete “August 201
Page 34 and 35: g) The number plate does not face t
Page 36 and 37: f) Seatbelt webbing that is.1. Dama
Page 38 and 39: d) the number plate light is not di
Page 42 and 43: c) Electrical wiring is not securel
Page 46 and 47: system was installed by the origina
Page 48 and 49: NOTE 1: Reinforcement plates attach
Page 50 and 51: 10.11 Visually inspect the LPG elec
Page 55 and 56: g) All electrical wiring, connector
Page 57 and 58: 12.10 Visually inspect body panels,
Page 59 and 60: c) any of the above lights are dama
Page 61 and 62: 12.25 Visually inspect the exhaust
Page 63 and 64: Section 13:Motor HomesMotor vehicle
Page 65 and 66: Section 14:Light Trailers & Caravan
Page 67 and 68: NOTE:The free play measurement give
Page 69 and 70: 14.15 Inspect the mudguardsReasons
Page 71 and 72: Page 11 - Version controlAt the end
Page 73 and 74: Section 15:Light Vehicle Standards
Page 75 and 76: h) The tariff indicator lights are
Page 77 and 78: q) The vehicle is not fitted with a
Page 79 and 80: Section 16:Light Vehicle Standards
Page 81 and 82: Section 17:BusesNOTE:The general ro
Page 85 and 86: 17.6 Check StepsReason for rejectio
Page 87 and 88: Appendix A:Brake Drums and DiscsBra
Page 89 and 90: • For trailers with an ATM up to
Page 91 and 92:
Appendix C:Suspension Modifications
Page 93 and 94:
Appendix D:Lift Kits & SuspensionMo
Page 95 and 96:
Appendix E: GROUND CLEARANCEREQUIRE
Page 97 and 98:
Appendix F:Retreaded TyresThe Trans
Page 99 and 100:
Appendix G:Windscreen Damage and Re
Page 101 and 102:
Tasmanian Inspection Manual for Lig
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Appendix J:Lighting Standardsa) Lig
Page 109 and 110:
Appendix K: Headlamp testing Screen
Page 111 and 112:
Appendix L:LPG and CNG Certificatio
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
ersion 4 - 1 May 2009 Page 128Light
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Appendix N:Missing Compliance Plate
Page 131 and 132:
Appendix O:Modifications BrochureIn
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Appendix P:Vehicle Modification Cod
Page 153 and 154:
D1 Rear Axle/s InstallationD2 Diffe
Page 155 and 156:
Appendix Q:Checking for RustA.1 Cla
Page 157 and 158:
NOTE: Because of differing structur
Page 159 and 160:
Noise Test ProceduresforIn-Service
Page 161 and 162:
ForewordThe National Transport Comm
Page 163 and 164:
Table of Contents1. Definitions 160
Page 165 and 166:
4 Test method for all vehicles exce
Page 167 and 168:
nominal axis of maximum sensitivity
Page 169 and 170:
Page 171 and 172:
Appendix S:Checking Vehicle Identif
Page 173 and 174:
APPENDIX T:Building Small TrailersN
Page 175 and 176:
Vehicle Standards Bulletin 11. SCOP
Page 177 and 178:
Vehicle Standards Bulletin 1c) The
Page 179 and 180:
Vehicle Standards Bulletin 1(Refer
Page 181 and 182:
Vehicle Standards Bulletin 1Typical
Page 183 and 184:
Vehicle Standards Bulletin 111.9 Ho
Page 185 and 186:
12.9 Width (Overall Width)Vehicle S
Page 187 and 188:
13. LIGHTING.Vehicle Standards Bull
Page 189 and 190:
Vehicle Standards Bulletin 113.1 Fr
Page 191 and 192:
Vehicle Standards Bulletin 1FIGURE
Page 193 and 194:
Vehicle Standards Bulletin 1FIGURE
Page 195 and 196:
Vehicle Standards Bulletin 1Note Ma
Page 197 and 198:
Vehicle Standards Bulletin 1NoteBec
Page 199 and 200:
16.2 Drawbar Safety ChainsVehicle S
Page 201 and 202:
Vehicle Standards Bulletin 1A coupl
Page 203 and 204:
Vehicle Standards Bulletin 119: AXL
Page 205 and 206:
Semi-trailersVehicle Standards Bull
Page 207 and 208:
23.3 Structural RequirementsVehicle
Page 209 and 210:
Vehicle Standards Bulletin 127. USE
Page 211 and 212:
Vehicle Standards Bulletin 11 Name
Page 213 and 214:
Appendix U:Light Trailer Requiremen
Page 215 and 216:
Tow Couplings - 50mm Ball Type Coup
Page 217 and 218:
6. Axle Rating (including wheels an
Page 219 and 220:
Appendix VInspection ofTyre Load an
Page 221 and 222:
Appendix WVSS VEHICLE IDENTIFICATIO
Page 223 and 224:
VSS VEHICLE IDENTIFICATION AND ENGI
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Light Vehicle Inspection ManualVers
show all

Light Vehicle Inspection Manual (PDF 7MB) - Transport

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?