Altivar 58 Telemecanique - error

Adjust MenuThe following parameters can be accessed once the I/O have been reassigned on the basic product.ENGLISHCode Description Adjustment range Factory settingAC2 Accel. 2 - s 0.05 to 999.9 5 s2nd acceleration rampdE2 Decel. 2 - s 0.05 to 999.9 5 s2nd deceleration rampThese parameters can be accessed if the ramp switching time (parameter Frt) is other than 0 Hz orif a logic input is assigned to ramp switching.IdC DC Inj.curr - A 0.10 to 1.36 In (1) Acc. to controller ratingDC injection braking currentThis parameter can be accessed if a logic input is assigned to DC injection stopping.After 30 seconds the injection current is peak limited to 0.5 Ith if it is set at a higher valueSP2 Preset Sp.2 - Hz LSP to HSP 10 Hz2nd preset speedSP3 Preset Sp.3 - Hz LSP to HSP 15 Hz3rd preset speedSP4 Preset Sp.4 - Hz LSP to HSP 20 Hz4th preset speedSP5 Preset Sp.5 - Hz LSP to HSP 25 Hz5th preset speedSP6 Preset Sp.6 - Hz LSP to HSP 30 Hz6th preset speedSP7 Preset Sp.7 - Hz LSP to HSP 35 Hz7th preset speedJOG Jog Freq. - Hz 0 to 10 Hz 10 HzJog frequencyJGt JOG Delay - s 0 to 2 s 0.5 sAnti-BrkLgSeqFlwd delay between two consecutive jog operationsbrL BrReleaseLev- Hz 0 to 10 Hz 0 HzBrake release frequencyIbr BrRelease I - A 0 to 1.36In(1) 0 ABrake release currentbrt BrReleasTime- s 0 to 5 s 0 sBrake release timebEn BrEngage Lev- Hz 0 to LSP 0 HzBrake engage frequencybEt BrEngageTime- Hz 0 to 5 s 0 sBrake engage time(1) In corresponds to the speed controller nominal current indicated in the catalog and on the speed controlleridentification label for "high torque" applications.80