IMAGE 42 /62 - SEAL Graphics

Emergency Stop ButtonsThere are two buttons and they are located on the top of the left and right cabinets of the machine.They shut down the rotation and movement of the rollers and should only be used in the case ofan emergency. Once pressed these buttons lock, and they must be rotated to be reset before themachine can be used again. After being reset, the rollers will move to their upper position.See also Safety Information section.EnEmergency Stop buttonLoading RollsHow to load the laminator:Step 1 - From the rear of the laminator, load the required rolls ontothe top and bottom unwind positions ensuring that the rubberblocking cords are on the top and bottom of the shaft. Release theunwind tension if necessary, to turn the shaft to the correct position.☞NOTE:The adhesive side of the film should be facingyou.Step 2 - Centre the rolls in relation to each other by measuring fromcore of the roll to the side panel of the laminator. Both rolls shouldhave the same distance.WARNING:Do not overload the unwind shafts whileloading/unloading.23