IMAGE 42 /62 - SEAL Graphics

Laminating and Adhesive Coating (Decaling)Preparation:Select the films that you will use on the top and bottom of the images,it is advisable to use slightly wider width films compared to the printwidth. This way the print can be trimmed with a border, so as toreduce waste, but be enough to leave a border. Mount rolls onto theunwind shafts with the adhesive facing you. Web as follows:Step 1a - Linerless films - pull the film down from the top unwindstation and thread under the idler bar (unless pressure sensitive isused, then thread above idler). Pull the film evenly over the top rollerand across the face of the rollers.Step 1b - Linered films - pull the film down from the top unwindstation and thread under the idler bar. Connect the film and liner tothe take up station with a piece of tape. The take-up station shouldhave a scrap core placed over it to allow easy removal of the scrapliner. Split the film from the release liner and pull the film evenlyacross the face of the rollers.EnWebbing film (film + liner)Step 2 - Remove image guard and swing the table into the upperposition.☞NOTE: Check if the film widths of the upper and lowerweb are the same!NEVER use the pull rollers when decaling!29